Best sellers

Audio preamplifier based on the NE5532 chip. Powered with DC voltage in the range from 9 to 35 V (does not require symmetrical voltage)

Stereo audio isolator based on two transformers. It allows to eliminate noise in the audio path resulting from different ground resistances of the sound source and the receiver

A module with an electret microphone and an amplifier that will allow you to detect a voice, a clap or a door slam using the analog output

2-channel stereo audio mixer in a metal housing. It has four outputs, on which the summed signal from 2 inputs is available. It is powered with the voltage from 5 to 19 V

The most popular Sn60Pb40 SW26 solder is a high-quality lead product with SW26 flux, intended for professional soldering in electronics and electrical engineering, meeting the EN ISO 9453:2014 standard

RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors

Game console based on the RP2040 microcontroller from Raspberry Pi. Equipped with a 1.54" LCD display, LiPo battery and aluminum housing. It has API support that allows you to create your own games in C++ and MicroPython. Pimoroni PIM559

Module with a display designed to indicate the battery level. TM1651 controller, control via the I2C interface. DFRobot FIT0466

Class A audio amplifier with one channel, 25 W. Built on the popular design of J. Hood from 1969. The set includes 2 pieces

Compact engine with 75: 1 LP transmission, shaft speed is 290 rpm, torque is 0.8 kg * cm (0.08 Nm), plate with connector PH 2.0. DFRobot FIT0457

FDC6420C; MOSFET N / P transistor; SSOT-6, Fairchild / On Semiconductor

The A-Cute Car is an FPGA-based three-wheeled robotic car kit. This car can provide higher operation performance than the MCU based robotic car, because the FPGA provides more powerful computing power than the MCU. P0467

Alphanumeric LCD display 20x4 characters with green backlight. Equipped with an I2C converter

Universal test probes for multimeters. The kit includes two probes (without wires) in red and black

Bluetooth module with integrated HC-08 system. Thanks to the angular pin connector with the bus signals, it is possible to easily connect the module to the contact plate or wires

The adapter allows you to connect the antenna with the SMA 50 Ω female connector to the device with the uFL socket (also known as u.FL, IPEX, IPAX, IPX, MHF, AM). The cord has a length of 20cm.

IDC male socket, 10-pin straight, pitch 1.27 mm. Designed for mounting on printed circuit boards. RoHS

Module with MLX90614-DCC sensor for non-contact temperature measurement in the range from -70℃ to 380℃. I2C communication. DFRobot SEN0206

RYU002N05, MOSFET transistor, N channel, 0.9V, UMT3

Module with acceleration and rotational speed sensor based on the MPU6050 system. It communicates via the I2C or UART interface