Best sellers
There are 16501 products.
LoRa module working on the 868 MHz frequency band with built-in RP2040 microcontroller, CH340 USB to UART converter, 74HC125V voltage level converter. SB Components 23240
Audio module with two microphones and display designed to work with the Raspberry Pi. Pimoroni PIM524
This module features a fixed-gain, 38 kHz modulated IR sensor and a corresponding IR LED with oscillator circuit to make a tiny proximity sensor. This low-brightness version draws an average of 8 mA at 5 V and has a typical sensing range up to approximately 12 inches (30 cm).
Linear battery charger Li-Ion; 4,0 ... 6,7V; LFCSP-20; Analog Devices; Compliance
Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16445
Gravity: 360 Degree Hall Angle Sensor is a rotation angle sensor measuring a value in the range of 0-360 ° with an analogue output, powered by 5V. DFRobot SEN0221
Module with a linear vibration motor and DRV2605L driver, which offers several pre-programmed modes of movement and allows you to program your own patterns. Communication via the I2C interface. Pimoroni PIM452
Module with air quality sensor SGP30. It allows you to read the concentration of VOC (TVOC) and eCO2 and communicates via the I2C interface. Pimoroni PIM480
Module with a GPS PA1010D receiver with a built-in ceramic antenna. It can download data from the most popular navigation systems: GPS, GLONASS, GALILEO. Pimoroni PIM525
Base board compatible with Arduino. It was equipped with an ATmega328P microcontroller. It has 22 I / O lines (including 6 PWM channels) and 8 analog inputs and a Qwiic connector. SparkFun DEV-18158
Station with two separate panels for a 75W (200-480 deg. C) soldering gun and hotair (100-480 deg. C).
Module with WM8960 audio codec to support 1 W stereo speakers and two microphones via I2S interface. SB Components 24087
Adafruit 2348
The module with 6 capacitive touch buttons and LED diodes, designed to work with the Raspberry Pi. The buttons are connected to the minicomputer via the CAP1166 controller, which communicates via the I2C interface. Pimoroni PIM272
Prototyping kit dedicated to micro:bit. It offers pin leads, a contact plate, buttons, LEDs and a buzzer. SB Components 22717
Shielded FTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCF6-10CC-0150-G
MicroMod main module with iMXRT1062 microcontroller. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SprakFun DEV-16402
Extension module designed for home automation projects compatible with Raspberry Pi. The board is equipped with a 24 V 2 A relay, three buffer inputs, three sink outputs and three analog inputs with a working range up to 24 V. Pimoroni PIM487
Shielded FTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCF6-10CC-1000-S