Best sellers

ARM Cortex-M3 CPU, 512kB Flash, 64kB RAM, USB, CAN, 5xUART, 2xI2C, 2xSPI, ADC, STM, LQFP144, RoHS

Bluetooth module with integrated HC-08 system. Thanks to the angular pin connector with the bus signals, it is possible to easily connect the module to the contact plate or wires

Scrolling message - set for self-assembly

Pilot tester ir remote control - set for self-assembly

Large momentary button with a diameter of 100 mm with LED backlight. It was based on a limit switch. The housing is black

Kitchen timer - set for self-assembly

C/CS mount lens with adapter. Allows a zoom of up to 100X, making it suitable as a microscope lens. Designed for use with the Raspberry Pi HQ camera. Waveshare 100X Microscope Lens for Pi

Waterproof latching button with a diameter of 12 mm and a height of 25 mm in a stainless steel housing. Yellow color

A module with a microSD card slot and a pin connector (2.54 mm pitch). It has a built-in voltage regulator and a voltage level converter. The SPI interface lines are led out on the connector

Probe for measuring direct and alternating current up to 100 A. It works in the 800 kHz band, it can be connected to the oscilloscope through the BNC connector. Powered by USB. Micsig CP2100A

Module with ACHS-7122 current sensor with a measuring range of direct and alternating current from -20 to 20 A. It communicates via an analog interface. Pololu 4031

Module with ACHS-7121 current sensor with a measuring range of direct and alternating current from -10 to 10 A. It communicates via an analog interface. Pololu 4030

Module with ACS724 current sensor with a measuring range of direct and alternating current from 0 to 10 A. It communicates via an analog interface. Pololu 4045

MSP430 Low Power MCU, 16kB Flash, 512B RAM, DIP20, TI, RoHS

A module with a USB type C connector designed for device prototyping. The pins are led out on a connector with a 2.54 mm pitch, which greatly facilitates the use of USB type C, e.g. with contact plates. Pololu 3411

Power multiplexer based on Texas Instruments TPS2113A. It enables smooth switching between two power sources from 2.8 V to 5.5 V. Pololu 2596

Development kit with nRF52840 microcontroller with ARM Cortex M4F core and BLE communication. Equipped with motion sensors and a microphone. Seeed Studio 102010469

Module with a potentiometer with a rotation range of 270 ° with an analog output. Compatible with 3.3 V and 5 V

Kit includes 6 spools of yellow, green, red, blue, black and white wires with silicone flexible insulation. The set also includes heat shrink tubing, cable ties, insulation stripper and insulation tape

4/8 position control stick with trigger. It has ZIPPY type leads so can be easily integrated into existing designs. Shooter Arcade Joystick