TermDriver 2 is designed for communication and diagnostics of UART interfaces in embedded systems. The device operates as a USB-UART converter, enabling simultaneous data transmission and real-time monitoring via a built-in IPS display with ANSI terminal support. This allows analysis of serial communication, monitoring of control signals and quick identification of connection issues without additional software on a computer.


The system is based on the RP2040 microcontroller with dual ARM Cortex-M0+ cores, enabling parallel handling of communication and display rendering. The device supports a wide range of baud rates and includes a 32 kB hardware buffer, reducing the risk of data loss under high load. Standalone operation allows the module to be used as a diagnostic console in embedded systems without requiring a connected computer.
Manufacturer
Responsible person
UART - RS232 converter with DB9 socket. Waveshare rs232-board
Overlay module for Raspberry Pi with GSM, GPRS, GNSS and Bluetooth
Xbee USB adapter based on the FTDI chip. Intended for configuring Xbee modules. Thanks to the female goldpin connector, it can be used as an FTDI programmer for Arduino FIO / pro / mini / lilypad. DFRobot DFR0050
The UART-USB converter built on the FTDI FT232RL chip. Compatible with 3.3V and 5V voltages. DFRobot DFR0065
USB - UART converter based on the FT232RL chip. Compatible with voltages of 3.3 V and 5 V, it is equipped with a microUSB connector. Cytron UC00A
No product available!
USB - UART TTL converter based on the FT232RL chip, the module is equipped with a miniUSB socket. Works with 3.3V or 5V voltage levels.
USB port isolator based on the ADUM3160 chip. The device has a rated insulation voltage of 1500V. The isolator is powered from the USB port.
A small USB-UART TTL converter module based on the CH340 system with a USB type A connector. Designed for the ESP-01 and ESP-01S modules
UART-RS232 converter module. The board was equipped with a Grove and DB9 connector. Seeed Studio 103020192
USB adapter designed for XBee modules. It can be connected to a computer with a USB cable and used with the X-CTU software to configure the XBee. DFRobot DFR0174
RS232 - UART converter module based on the MAX3232 chip. There is a DB9 connector on the board and a 4-pin connector with a 2.54 mm pitch
USB - RS-232 USB A (m) / D-Sub (m) cable with a length of 1 m. Akyga AK-CO-02
The module with the UART-RS232 converter is designed to work with the Raspberry Pi Pico. It has a built-in SP3232EEN chip and enables data transmission between the UART interface and the RS232 device. Waveshare Pico-2CH-RS232
The base plate is dedicated to ESP32 CAM modules. It allows you to connect the camera via a USB interface, e.g. to a computer. ESP32-CAM-MB
A module with a USB converter - GPIO/ADC/I2C based on the MCP2221A chip. It allows you to connect sensors, displays or PWM drivers to the computer via a 2.54 mm or Stemma QT/Qwiic connector. Adafruit 4471
USB-UART converter with built-in IPS display for real-time serial monitoring, supports up to 2 Mbit/s, RP2040 microcontroller, 3,3 V 350 mA power output. Adafruit 6460