![GPS-RTK Dead Reckoning pHAT - GPS module for Raspberry Pi GPS-RTK Dead Reckoning pHAT - GPS module for Raspberry Pi](https://kamami.pl/36928-large_default/gps-rtk-dead-reckoning-phat-gps-module-for-raspberry-pi-gps-16475.jpg)
![GPS-RTK Dead Reckoning pHAT - GPS module for Raspberry Pi GPS-RTK Dead Reckoning pHAT - GPS module for Raspberry Pi](https://kamami.pl/36928-large_default/gps-rtk-dead-reckoning-phat-gps-module-for-raspberry-pi-gps-16475.jpg)
zł1,625.20 tax excl.
GPS module with u-blox ZED-F9R. Uses Automotive Dead Reckoning (ADR) technology. Provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-16475
free shipping in Poland for all orders over 500 PLN
If your payment will be credited to our account by 11:00
Each consumer can return the purchased goods within 14 days
GPS module with u-blox ZED-F9R. The module uses Automotive Dead Reckoning (ADR) technology. Provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. The ZED-F9R module can receive signals from the GPS, GLONASS, Galileo and BeiDou constellations with an accuracy of 0.2 meters (supports simultaneous reception of four GNSS systems). The module provides position accuracy in cities or in covered areas. Continuous positioning is ensured even under weak signal conditions and is available in the event of total signal loss (e.g. short tunnels and garages). The ZED-F9R is an excellent solution for autonomous robots that require accurate positioning in difficult conditions.
Attention!
For proper operation, the module requires a GPS antenna, which is not included in the set. It must be purchased separately.
The module has a 40-pin GPIO connector compatible with Raspberry Pi, NVIDIA Jetson Nano or Google Coral. The board also has a Qwiic connector and a USB Type-C connector for communication with the system.
Antenna with built-in LNA amplifier with high sensitivity, for mounting in a device using a GPS module. The antenna has a 75mm cable, terminated with a U.FL plug (IPEX). Dimensions of the device: 25 x 25 x 4 mm
No product available!
No product available!
No product available!
NVIDIA development kit with the ARM Cortex A57 1.43GHz CPU chip and the Maxwell graphics system consisting of 128 cores supporting CUDA technology. The module has a DDR4 4GB RAM memory. NVIDIA Jetson Nano Development Kit rev. B01 945-13450-0000-100
No product available!
Single board computer with SOM module NXP i.MX 8M processor, has 1 GB of RAM, 8GB of eMMC memory, wireless communication and TPU coprocessor. It includes numerous connectors, including USB 2.0 / 3.0 ports, DSI interface, CSI-2, Ethernet port, audio connectors and a 40-pin GPIO connector. Coral Dev Board
No product available!
The latest version of the Raspberry Pi series: Raspberry Pi 4 model B with quad-core SoC (Broadcom BCM2711, Cortex-A72) working at 1.5GHz, 2GB RAM LPDDR4, Broadcom VideoCore VI.
The long-awaited Raspberry Pi 4 model B with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5GHz, 4 GB LPDDR4 RAM and the Broadcom VideoCore VI graphics chip
The long-awaited Raspberry Pi 4 model B with the SoC Broadcom BCM2711 SoC (4 x Cortex-A72) running at 1.5GHz, 8 GB LPDDR4 RAM and the Broadcom VideoCore VI graphics chip
GNSS receiver module dedicated to Raspberry Pi minicomputers. It provides simultaneous reception of up to three types of satellite systems, including GNSS with GPS, Beidou, Galileo and GLONASS. Waveshare NEO-M8T GNSS TIMING HAT
No product available!
Expansion board with LoRa Node SX1262 module and GNSS L76K dedicated for Raspberry Pi. It supports the LoRaWAN protocol and allows communication in the 433 MHz frequency band and enables positioning within the GPS, GLONASS, BDS and QZSS systems. Waveshare SX1262 433/470M LoRaWAN/GNSS HAT
Adafruit 2324
Expansion board with LoRa Node SX1262 module and GNSS L76K dedicated for Raspberry Pi. It supports the LoRaWAN protocol and allows communication in the 868 MHz frequency band and enables positioning within the GPS, GLONASS, BDS and QZSS systems. Waveshare SX1262 868/915M LoRaWAN/GNSS HAT
Kit with the LTE Cat-6 EM06-E module designed to work with the Raspberry Pi minicomputer. It supports communication within the fast LTE-A network and GNSS positioning. Waveshare EM06-E LTE Cat-6 HAT
No product available!
GPS module with LC29H GNSS receiver designed to work with the Raspberry Pi minicomputer. It allows you to receive data from major positioning systems, including GPS, QZSS, GLONASS, Galileo and BeiDou, and supports fast, dual-band RTK positioning. Waveshare LC29H(BS) GPS/RTK HAT
No product available!
GPS module with GNSS receiver ZED-F9P. It can receive data from GPS, GLONASS, Galileo and BeiDou systems. It has USB, UART, I2C and SPI interfaces. RTK and high accuracy up to 10 mm. Waveshare ZED-F9P GPS-RTK HAT
No product available!
Small GPS location module with L80-39 GPS chip, USB and TTL two ports,easy to be used with Raspberry Pi, Arduino, STM32 and other kind of micrcontrollers. The GPS module uses NMEA0183 communication protocol, integrated ultra-small SMA antenna connector. DFRobot TEL0119
Seeed studio LoRa / GPS HAT is an extension designed for Raspberry Pi 2 minicomputers (model B) and Raspberry Pi 3. It has a LoRa communication module (868 MHz) and a GPS module. Seeed Studio 113990254
No product available!
KAmodRPi-GPRS-GPS is an overlay for Raspberry Pi 4 / 3B + / 3B / 2B / B + computers, which allows you to enrich the system with the ability to send data via GPRS, SMS transmission or work as a module for Bluetooth communication. This extension also offers the ability to receive satellite data from location systems - GPS and GLONASS.
GNSS module based on the L76B chip that can work with GPS, BDS and QZSS systems. Communication via a UART interface. SB Components 24056
Set with SIMCom 5G SIM8202G-M2 module designed to work with the Raspberry Pi minicomputer. It supports 5G SA or NSA networks and is backwards compatible with 4G and 3G networks. Waveshare SIM8202G-M2 5G HAT (B)
No product available!
GPS module with LC29H GNSS receiver designed to work with the Raspberry Pi minicomputer. It allows you to receive data from major positioning systems, including GPS, QZSS, GLONASS, Galileo and BeiDou, and supports positioning assistance systems (WAAS, EGNOS, MSAS and GAGAN) and EASY technology. Waveshare LC29H(AA) GPS HAT
GPS module with LC29H GNSS receiver designed to work with the Raspberry Pi minicomputer. It allows you to receive data from major positioning systems, including GPS, QZSS, GLONASS, Galileo and BeiDou, and supports the RTK function as a base station. Waveshare LC29H(DA) GPS/RTK HAT
GPS module with u-blox ZED-F9R. Uses Automotive Dead Reckoning (ADR) technology. Provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-16475