modNRF24L01_01

Expansion board for STM32 Nucleo based on S2-LP RF transmitter operating in 868MHz band. The expansion board is compatible with ST morpho and Arduino UNO R3 connectors. STMicroelectronics X-NUCLEO-S2868A2

DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112

ModCC2540-A1 allows the use of Bluetooth transmission features BLE 4.0 - thanks to the built-in CC2540 chip, it is possible to create complex projects without the use of an additional microcontroller. modCC2540-A1

Adapter with 3.3V voltage regulator designed for NRF24L01 modules with 8-pin connector

A set with a radio transmitter and receiver operating at 315 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 113020001

Multi-channel wireless data transmission module operating at 433 MHz. It is supplied with the voltage ranging from 3.2 V to 5.5 V and communicates via the UART interface

Wireless transceiver operating in the 915MHz band based on the RFM69HCW chip with a maximum power of 100mW and a transmission speed of up to 300kbps. The range in open space is up to 500m. The module communicates via the SPI bus. Arduino compatible. modRFM69HCW_915MHz

Radio module with the RFM69HCW (868 MHz or 915 MHz) system, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4072

Module with nRF24L01 + transceiver, power amplifier and antenna with 2dBi gain, 1000m, 2Mb / s, RoHS

A GFSK transceiver operating in the ISM 2400 ... 2483.5 MHz frequency range. Powered by a voltage of 1.9 ... 3.6 V, the pins are goldpin connectors. It has a built-in PCB antenna. HOPE MICROELECTRONICS RFM75-S

A set with a radio transmitter and receiver operating at 433 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 104020002

Radio module with RFM69HCW 433 MHz chip, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4073

A set with a radio transmitter and receiver operating at 433 MHz. The modules are equipped with Gravity connectors and communicate via a digital interface. DFRobot TEL0140-1

The FS1000A transmitter and the MX-RM-5V receiver enable communication in the ISM band; they are easy to use, do not require advanced bus control and have very small dimensions. Especially recommended for work with Arduino and STM32

The ISM radio module in the DIP housing. It operates on the 868 MHz frequency. The module complies with FCC, ETSI regulations. HOPE MICROELECTRONICS RFM12B-868DP