zł19.00 tax excl.
Long-range Sub-GHz wireless RF transmitter and receiver module, capable of operating in the 868 MHz frequency band. The integrated architecture allows the use of a minimum number of external components while maintaining maximum design flexibility. Hoperf RFM22B-868S2
RFM22B is an integrated ISM transceiver module operating on the 868 MHz frequency band. Its low receive sensitivity (-121 dBm) combined with industry-leading output power of +20 dBm provides extended range and improved link performance. Built-in antenna diversity and frequency hopping support can be used to further increase range and enhance performance.
Additional system features such as automatic wake timer, low battery detector, 64-byte FIFO TX/RX, packet handling, and preamble detection reduce overall power consumption and allow for the use of cheaper MCUs in the system. Integrated temperature sensor, general-purpose ADC, power-on reset (POR), and GPIO further lower costs and system size.
The digital receive architecture of RFM22B includes an ADC and DSP-based modem that performs demodulation, filtering, and packet handling, increasing flexibility and performance. Direct digital transmit modulation and automatic PA power ramping provide precise transmit modulation and reduced spectral spreading, ensuring compliance with global regulations including FCC and ETSI.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
A long-range RF sub-GHz wireless transceiver module capable of operating in the 433 MHz frequency band. The integrated architecture allows the use of a minimum number of external components with maximum design flexibility. RFM69HW433
A long-range RF sub-GHz wireless transceiver module capable of operating in the 868 MHz frequency band. The integrated architecture allows the use of a minimum number of external components with maximum design flexibility. RFM69HW868
Long-range Sub-GHz wireless RF transmitter and receiver module, capable of operating in the 433 MHz frequency band. The integrated architecture allows the use of a minimum number of external components while maintaining maximum design flexibility. Hoperf RFM69HW-433S
The FS1000A transmitter and the MX-RM-5V receiver enable communication in the ISM band; they are easy to use, do not require advanced bus control and have very small dimensions. Especially recommended for work with Arduino and STM32
DFRobot 315MHz RF receiver module using SC2272-L4 low power decoder chip. DFRobot TEL0112
WIFI-LPT100 Eval Kit module enables UART data transmission via WiFi, ultra low power consumption, encrypted communication
No product available!
A GFSK transceiver operating in the ISM 2400 ... 2483.5 MHz frequency range. Powered by a voltage of 1.9 ... 3.6 V, the pins are goldpin connectors. It has a built-in PCB antenna. HOPE MICROELECTRONICS RFM75-S
HAT module with RFM95W 868 MHz system for LoRa/LoRaWAN communication and OLED display, designed for Raspberry Pi minicomputers. Adafruit 4074
Radio module with the RFM69HCW (868 MHz or 915 MHz) system, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4072
No product available!
Radio module with RFM69HCW 433 MHz chip, designed to work with the Raspberry Pi. Equipped with an OLED display and buttons. Adafruit 4073
Expansion board for STM32 Nucleo based on S2-LP RF transmitter operating in 868MHz band. The expansion board is compatible with ST morpho and Arduino UNO R3 connectors. STMicroelectronics X-NUCLEO-S2868A2
Module with 2.4 GHz transceiver system (transmitter and receiver) LT892. It is powered with the voltage of 3.3 V and has a built-in antenna
No product available!
Multi-channel wireless data transmission module operating at 433 MHz. It is supplied with the voltage ranging from 3.2 V to 5.5 V and communicates via the UART interface
A set with a radio transmitter and receiver operating at 433 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 104020002
A set with a radio transmitter and receiver operating at 315 MHz. The modules are equipped with Grove connectors and communicate via a digital interface. Seeed Studio 113020001
6-channel transmitter (RC apparatus) 2.4 GHz Flysky FS-i6 with LCD display in set with receiver FS-IA6 with telemetry support. 6V power supply (4 x AA battery). Left-hand throttle (right-handed version). Flysky FS-i6
No product available!
Wireless communication module based on the NRF24L01 chip. It is designed for SMD mounting and will be perfect for the construction of small devices
No product available!
Module with a 433 MHz radio receiver for M5Stack sets. Based on the SYN531R chip, it has a built-in PCB antenna. M5Stack U113
Long-range Sub-GHz wireless RF transmitter and receiver module, capable of operating in the 868 MHz frequency band. The integrated architecture allows the use of a minimum number of external components while maintaining maximum design flexibility. Hoperf RFM22B-868S2