X-NUCLEO-S2868A2 - expansion board with RF transmitter S2-LP 868MHz
ID: 578641
5906623410590
zł161.81
Tax included
zł131.55 tax excl.
Expansion board for STM32 Nucleo based on S2-LP RF transmitter operating in 868MHz band. The expansion board is compatible with ST morpho and Arduino UNO R3 connectors. STMicroelectronics X-NUCLEO-S2868A2
Description
X-NUCLEO-S2868A2 is an expansion board based on the S2-LP ultra-low power RF transmitter. The transmitter works in the ISM 868 MHz band. The set has support for 6LoWPAN (IPv6 over Low-Power Wireless Personal Area Networks) networks thanks to the libraries available in the STM32CubeMX package.
X-NUCLEO-S2868A2 can work with STM32 Nucleo kits via SPI interface and GPIO pins. The expansion board is compatible with ST morpho and Arduino UNO R3 connectors.
Features
- Based on S2-LP radio
- S2-LP narrow band ultra-low power sub-1 GHz transceiver tuned for 860 - 940 MHz frequency band
- Programmable RF output power up to +16 dBm
- Modulation schemes: 2-FSK, 2-GFSK, 4-FSK, 4-GFSK, OOK and ASK
- Air data rate from 0.1 to 500 kbps
- Ultra-low power consumption: 7 mA RX and 10 mA TX at +10 dBm
- IEEE 802.15.4g hardware packet support with whitening, FEC, CRC and dual SYNC word detection
- RX and TX 128 byte FIFO buffers
- Support to wireless M-Bus
- Excellent performance of receiver sensitivity (up to -130 dBm)
- Automatic acknowledgement, retransmission and timeout protocol engine
- Compatible with STM32 Nucleo boards
- Compatible with Arduino UNO R3 connectors
- BALF-SPI2-01D3 IPD balun for matching network and harmonics filter
- Sigfox compatible
- Sample firmware for P2P communication
- 6LoWPAN compatible thanks to STM32Cube
578641
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
You might also like
Arduino Uno Rev3 is a popular board with Atmel ATmega328 microcontroller from the AVR family, there are 14 I / O lines, 6 PWM channels and 6 analog inputs. The additional ATmega16U4 microcontroller realizes communication via the USB interface. Arduino A000066
zł108.42
Delivery date unknown
No product available!
STM32 Nucleo development board for STM32 F4 series - with STM32F401RE MCU, 512KB flash memory, STM, RoHS
zł65.92
24h
Available quantity: 5
Available
STM32 Nucleo development board for STM32 L1 series - with STM32L152RE MCU, 512KB flash memory, STM, RoHS
zł84.01
24h
Available quantity: 6
Available
The STEVAL-FKI868V2 evaluation board is based on the S2-LP sub-1GHz ultra-low power low data-rate transceiver suitable for ISM bands and wireless M-Bus. The NUCLEO-L053R8 motherboard is equipped with an STM32L0 low power microcontroller to control the S2-LP
zł361.71
24h
Available quantity: 1
Available
The STEVAL-FKI433V2 evaluation board is based on the S2-LP sub-1GHz ultra-low power low data-rate transceiver suitable for ISM bands and wireless M-Bus. The NUCLEO-L053R8 motherboard is equipped with an STM32L0 low power microcontroller to control the S2-LP
zł368.37
24h
Available quantity: 1
Available
Other products in the same category (16)
The X-NUCLEO-53L0A1 expansion board features the VL53L0X ranging and gesture detection sensor, based on ST’s FlightSense™, Time-of-Flight technology. It is an evaluation board that provides an introduction to the ranging and gesture detection capabilities of the VL53L0X module
zł183.28
1 weeks
No product available!
STSAFE-A110 based security module, compatible with STM32 Nucleo boards and Arduino UNO R3 connector boards. It provides simple integration of security functions such as data protection and authentication, and its cooperation with X-CUBE-SAFEA1 and X-CUBE-SBSFU software packages enables rapid implementation of STM32 microcontroller-based applications. STMicroelectronics X-NUCLEO SAFEA1B
zł79.22
24h
Available quantity: 2
Available
P-NUCLEO-IOD02A1 is an STM32 Nucleo kit consisting of NUCLEO-L452RE (IO-Link stack), X-NUCLEO-IOD02A1 (IO-Link physical layer) and X-NUCLEO-IKS02A1 (sensor module). The kit constitutes a full IO-Link device. P-NUCLEO-IOD02A1
zł458.29
24h
Available quantity: 3
Available
Multifunctional expander (shield) for NUCLEO and Arduino equipped with Bluetooth 2.0+EDR (HC-05) interface, MEMS 3DoF LIS35, LED-RGB, joystick and analog STLM20 temperature sensor developed and produced by KAMAMI.
zł99.00
24h
Available quantity: 36
Available
The set consists of the STM32 NUCLEO-F401RE board with the STM32F401RE microcontroller and the X-NUCLEO-53L3A2 board with the VL53L3CX distance sensors operating in ToF technology. STMicroelectronics P-NUCLEO-53L3A2
zł313.49
24h
Available quantity: 1
Available
The set consists of the STM32 NUCLEO-F401RE board with the STM32F401RE microcontroller and the X-NUCLEO-6180A1 board with the VL6180 distance sensors operating in ToF technology. STMicroelectronics P-NUCLEO-6180A1
zł271.90
24h
Available quantity: 2
Available
The X-NUCLEO-IKS02A1 industrial motion MEMS sensor expansion board is compatible with the Arduino UNO R3 connector layout. STMicroelectronics X-NUCLEO-IKS02A1
zł127.55
24h
Available quantity: 1
Available
The X-NUCLEO-IHM16M1 motor driver expansion board is based on the STSPIN830 monolithic driver for three-phase brushless motors. It represents an affordable, easy-to-use solution for driving brushless motors in your STM32 Nucleo project, implementing single and three-shunt current sensing
zł91.04
1 weeks
No product available!
Expansion module with color sensor VD6283. The cap is compatible with STM32 Nucleo boards. STMicroelectronics X-NUCLEO-6283A1
zł202.48
24h
Available quantity: 2
Available
An expansion board with several EEPROM memories from the M24xx and M95xx series, designed to work with STM32 Nucleo boards. STMicroelectronics X-NUCLEO-EEPRMA2
zł94.67
24h
Available quantity: 1
Available
Set consisting of the STM32 NUCLEO-F401RE board with the STM32F401RE microcontroller and the X-NUCLEO-53L4A2 board with the VL53L3CX ToF distance sensor. STMicroelectronics P-NUCLEO-53L4A2
zł349.68
24h
Available quantity: 4
Available
STM32 Nucleo expansion board designed to provide an application for the 16 channel LED driver LED1642GW. Depending upon the end application, RGB or single color LEDs can be connected to the board. Separate brightness control is possible for each channel. It is compatible with the STM32 Nucleo board family and equipped the Arduino™ UNO R3 connector layout. X-NUCLEO-LED16A1
zł104.28
1 weeks
No product available!
X-NUCLEO-PGEEZ1 is a versatile EEPROM memory expansion module that allows for easy integration with STM32 Nucleo boards. With its SPI interface, this module offers developers the ability to test and evaluate EEPROM memory with a capacity of up to 32 Mbit. It is an ideal solution for storing critical data in industrial applications, such as calibration, user settings, and monitoring. X-NUCLEO-PGEEZ1
zł226.53
24h
Available quantity: 1
Available
Multifunctional board for STM32 NUCLEO, built based on operational amplifiers. Has, among others built-in LED current controller, prototype area and window discriminator
Regular pricezł132.75zł117.39
24h
Available quantity: 50
Available
The X-NUCLEO-IHM03A1 plate allows the control of a high-power stepper motor; the maximum current of the phase is 10A rms, additionally the controller enables execution up to 1/128 step and has a number of protections. X-NUCLEO-IHM03A1
zł51.99
24h
Available quantity: 3
Available
The X-NUCLEO-IHM15A1 dual brush DC motor driver expansion board is based on the STSPIN840 for STM32 Nucleo. It provides an affordable and easy-to-use solution for the implementation of compact motor driving applications such as thermal printers, robotics and toys
zł89.38
24h
Available quantity: 1
Available
Expansion board for STM32 Nucleo based on S2-LP RF transmitter operating in 868MHz band. The expansion board is compatible with ST morpho and Arduino UNO R3 connectors. STMicroelectronics X-NUCLEO-S2868A2