Gravity: Analog ADKeyboard Module V2 - keyboard with analog output (5 buttons)

Module with a bistable button and green LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-G

5-button keyboard module with analog output

Module with a button, LED diode and a white cap. DFRobot DFR0029-W

Module with a button, LED diode and a blue cap. DFRobot DFR0029-B

Module with a button and red LED backlight. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 111020044

Gravity: Joystick Module V2 is a joystick module with two analog outputs (X and Y axis) and a digital output (Z axis) supplied with 3.3 ... 5V voltage. DFRobot DFR0061

Module with a button and re LED backlight. Controlled by the I2C interface, it has a built-in debouncing mechanism, pull-up resistors as well as interrupts and a FIFO queue. SparkFun BOB-15932

CAP1188 - 8-Key Capacitive Touch Sensor Breakout - I2C or SPI - Adafruit 1602

8-position DIP-Switch Module

Waveshare 8 Push Buttons module provides 8 single push buttons in 1 board. Waveshare 3678

Conductivity Sensor Switch DFRobot is a touch button that allows you to change the sensor output status by connecting terminals (positive and negative) using metal, human body or fruit and plants. It is powered by 3.3 ... 5 V. DFRobot SEN0223

Touch Sensor Switch Module for Arduino, RoHS

Keyboard module with 10 tact switch buttons. The state of the buttons can be read using digital pins or a common analog output. DFRobot DFR0792

Membrane keypad module with 12 (3x4) buttons. It is equipped with a tape terminated with a 7-pin connector

Touch keyboard module with 8 buttons based on the TTP226 chip. It is equipped with a connector with derived signals and LEDs that indicate the state of each button

Module with a bistable button and yellow LED backlight. The board is equipped with a Gravity connector and communicates via a digital interface. DFRobot DFR0785-Y