Bluetooth 4.1 audio player with 3W amplifier + remote control

WM8960 stereo codec module with driver for 1W class D speakers and headphones. It uses the I2S interface and the I2C bus to configure the system. SparkFun BOB-21772

Audio receiver with Bluetooth 5.0 communication based on the QCC3008 module. It is equipped with an insulated converter that enables power supply with 5 V voltage

WAV files player module. It is based on a DAC converter and an audio amplifier, there is a 3.5 mm audio output on the board. The files are played from the microSD card. Adafruit 94

MP3 player with support for microSD cards and USB memory. It can work as a separate device and play sounds from a card or pendrive

Sound terminal expansion board based on STA350BW for STM32 Nucleo

Expansion module with stereo audio output equipped with LM4550 chip with AC\'97 codec. It allows you to play and record high-quality stereo sounds. Numato Lab EXPAUD003

Bluetooth audio receiver module enclosed in a housing that enables wireless transmission of sounds. It is equipped with a PCB antenna and a 3.5 mm audio jack

Bluetooth audio receiver module that allows wireless transmission of sounds. It is equipped with a PCB antenna and edge connectors

Module with VS1000D chip and SPI Flash memory, which allows you to play sounds in Ogg Vorbix and WAV format stored on a SPI Flash memory. SparkFun DEV-14006

Audio module with DAC, stereo amplifier and display, designed to work with the Raspberry Pi. Pimoroni PIM484

Audio player module with MP3 decoder and microSD card slot. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 107020069

MP3 panel with LCD display for installation in the audio device. It allows you to play files in MP3, WAV and WMA format from USB memory, microSD card, via AUX and Bluetooth 5.0. Has a built-in FM receiver. modBluAudRad

This breakout board, the ultimate companion for the VLSI VS1053B DSP codec chip, can decode a wide variety of audio formats MP3, AAC, Ogg Vorbis, WMA, MIDI, FLAC, WAV (PCM and ADPCM); it can be used to record audio in both PCM (WAV) and compressed Ogg Vorbis. 8 GPIO pins can be used for lighting up small LEDs or reading buttons. Adafruit 1381

Audio player with HiFi amplifier in aluminum housing. It allows you to play files from USB memory, SD card, via the audio connector and Bluetooth. It has a built-in FM receiver

Audio module with DAC, headphone amplifier and display, designed to work with the Raspberry Pi. It is based on the PCM5100A system and communicates via the I2S interface. Pimoroni PIM482

Simple and versatile module that converts I2S audio signals into analog signals, making it ideal for driving speakers with up to 3.2W of power.