- Out-of-Stock
JTAG-USB Full Speed Module
ID: 103145
JTAG-USB Full Speed Module
JTAG-USB Full Speed Module
The JTAG-USB Full Speed allows you to use your PC to connect to a JTAG scan chain or to access an SPI interface on a board equipped with the appropriate 6-pin header. In this way, you can program devices on Digilent programmable logic boards using the free Digilent Adept software. You can also program AVR microcontrollers on Digilent embedded control boards using the Digilent AVR programmer application.
Code: 210-153
The JTAG-USB Full Speed allows you to use your PC to connect to a JTAG scan chain or to access an SPI interface on a board equipped with the appropriate 6-pin header. In this way, you can program devices on Digilent programmable logic boards using the free Digilent Adept software. You can also program AVR microcontrollers on Digilent embedded control boards using the Digilent AVR programmer application.
Key Features:
- Low-cost JTAG configuration solution
- Connects to the USB port of a PC, and to a standard 6-pin JTAG programming header
- Can be used with Digilent Adept & AVR Device Programmer software
- Can program devices that have a JTAG voltage of 1.8V or greater
- Requires Adept 2.0 or later for operation
Code: 210-153
103145
Other products in the same category (16)
No product available!
No product available!
Wireless, accurate temperature and humidity sensor with built-in event memory (recorder)
Retired
No product available!
No product available!
A set of two aluminum brackets for mounting micro Pololu motors. Mounting screws included. Pololu 1599
Retired
No product available!
The module contains two tiny cores, an x86 (Quark) and a 32-bit ARC architecture core, both clocked at 32MHz. The Intel toolchain compiles your Arduino sketches optimally across both cores to accomplish the most demanding tasks
Delivery date unknown
No product available!
HK Turnigy nano-tech 6000mah 2S2P 65~130C Hardcase Lipo Pack (17265)
Retired
No product available!
No product available!
No product available!
No product available!
Filament from ROSA3D made of high-quality PLA pellets. Placed on a cardboard thimble, on which 1 kg of 1.75 mm diameter filament is wound. ROSA3D ReFill PLA Starter Yellow
Retired
No product available!
No product available!
CraftBot FLOW IDEX 3D printer made of the highest quality components, with a filament sensor, semi-automatic calibration and wireless connectivity. Thanks to its intuitive operation, the printer will be perfect for both professionals and beginners
Retired
No product available!
No product available!
No product available!
No product available!
JTAG-USB Full Speed Module