250-3.5-04P-11-00A(H) - spring terminal connector 4pin 3.5mm

Freescale starter kit with Kinetis KL25Z family microcontroller (Cortex-M0 +), integrated with the programmer-OpenSDA debugger, capacitive actuator, LED-RGB, MEMS 3D accelerometer and shield with MEMS sensors: MPL3115, MAG3110, MMA8491Q. Arduino-compatible outputs.

Compatible with Arduino UNO R3, Onboard MCU ATMEGA328P-AU. Waveshare: UNO PLUS

The Micsig DP series differential probe is based on advanced metal shielding technology. It offers a 150 MHz frequency band and the ability to measure voltages up to 7000 V. It uses the popular BNC connector and is powered by a USB Type-C connector. Micsig DP7001

ETHERNET-RS232 CONVERTER - PRINTED PLATE

MYIR MYS-7Z0007S-C is a single board module based on the Xilinx XC7Z007S-1CLG400C chip (Zynq-7007S). This system consists of a single-core processor based on Cortex-A9 core, which can operate at a maximum frequency of 667 MHz and Artix-7 FPGA. The computer is equipped with 512 MB of DDR3 SDRAM, 4 GB of eMMC memory and 16 MB of QSPI Flash memory

Audio cable with 3.5 mm 3-pin minijack plugs and 3 x RCA (chinch) 0.24 m long

Metal case with fan for Raspberry Pi 4 model B in black

PRINTED BOARD - SINGLE CHANNEL CONTROL SYSTEM BY PHONE

LPY550AL Dual-Axis (Pitch and Yaw or XZ) Gyro with ą500°/s and ą2000°/s Ranges

Assembled miniature 5V power supply module. AVT1913 / 5 C

1-channel monochrome system of adding subtitles on the image (OSD - On-Screen Display) with integrated EEPROM, TSSOP28, Maxim memory

The I2C-GPIO converter module is powered with the voltage of 5 V. It allows you to extend the number of digital pins of the Arduino-compatible board with an additional 16 IO pins. DFRobot DFR0013