- Out-of-Stock

COMPUTER TANK CONTROLLER - KIT FOR INDEPENDENT INSTALLATION
The system allows to control a model of a tank type vehicle, i.e. driven by two engines, where the left engine drives the left track (left wheel), and the right engine drives the right track (right wheel). Because in the 21st century it does not fall out any more - the model is controlled by a computer. The Windows program controls the model through the RS232 serial port. It allows you to control four activities: driving forward, turning left, turning right and stopping the model. Although there is a lack of the option of driving backwards, but in the case of a tank, it does not matter much. The tank is very manoeuvrable, turns virtually in place, making it easier to maneuver than using a car model. The program controls the model using a previously saved ride. It can be programmed "dry", predicting which way the model has to go through and entering it into the program. The second method consists in "recording" the drive of the manually controlled model (keyboard cursors). It gives fantastic possibilities. We can, for example, register the model ride from the room to the kitchen, then set the model to the place from which it started driving, and activate the driving playback program. Now our tank will go to the kitchen itself! It will simply recreate the previously saved ride. In this way, we can program the driving routes around the apartment.
The device is particularly recommended for modelers and users of military toys
Selected parameters:
Download
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Female terminal block, 2-pin. Pitch 3.81mm. Height 7.8mm. Suitable for 15EDGRC male strips with a pitch of 3.81 mm. 2EDGKN-3.81
No product available!
JTAG interface for ARM (USB) microcontrollers compatible with OpenOCD
No product available!
The ZL2USB module is a convenient interface for the exchange of data between a PC equipped with USB and any digital system equipped with UART. The module uses the FTDI FT232BM system.
No product available!
Waveshare AlphaBot, a basic set for building an Arduino-based robot
No product available!
No product available!
Cable with USB plugs type A and microUSB type B 2.0, cable length 3 m. LANBERG CA-USBM-10CC-0030-BK
No product available!
No product available!
No product available!
No product available!
No product available!
9.7" monitor with e-Paper screen equipped with a mini HDMI interface. It offers a resolution of 1200x825 pixels, a wide viewing angle and low power consumption. Waveshare EINK-DISP-97 (EU)
No product available!
No product available!
Development kit chipKIT DP32 equipped with PIC32MX250F128B microcontroller (40/50 Mhz, 128 kB Flash, 32 kB RAM), prototype area with solder pads, potentiometer, 4 LED diodes, 2 buttons and soldering pads for EEPROM memory and analog temperature sensor. Digilent 410-280P-KIT
No product available!
Base plate dedicated to the STM32F4DISCOVERY set. It offers all microcontroller interfaces on the connectors located on the edge of the board. Waveshare Open407V-D Standard
No product available!
Adafruit 1036 - Pi Holder milled aluminum case for Raspberry Pi without logo
No product available!
No product available!
COMPUTER TANK CONTROLLER - KIT FOR INDEPENDENT INSTALLATION