- Out-of-Stock
AVT2690 A
ID: 190250
LAMP BUFFER OR PICK UP AT HOME - PLATE
LAMP BUFFER OR PICK UP AT HOME - PLATE
Producer: AVT
The use of lamps is a great way to improve the sound of an audio system. A much cheaper solution than purchasing a new amplifier is to use a tube buffer plugged between the CD player and the amplifier. The device is to alleviate the sharp sound of especially cheaper, factory audio sets. The buffer changes the characteristics of the classic amp so that a typical, warm 'tube' sound is obtained. This is the effect of various types of distortion, in particular even harmonics. A double triode of low power was used to construct the putty.
The device is especially recommended for fans of tube audio equipment and connoisseurs of the 'old' sound
Selected parameters:
- cathode follower system
- ECC88 lamp
- high input impedance
- flat transmission characteristics in the 10 Hz - 200 kHz band
- power supply - 230 V
- printed circuit board and documentation included
Download
190250
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Other products in the same category (16)
No product available!
WIFI-LPT100-B is a small module that enables communication using a wireless WiFi network. It has a UART interface, and is characterized by low energy consumption.
Retired
No product available!
Odroid N2 4 GB CoreELEC Edition is a ready-made kit that allows you to build a home entertainment center (media center), based on the ODROID N2 minicomputer with 4 GB of RAM.
Retired
No product available!
Set ZL29ARM + module ZL3ETH + programmer ZL30PRGv2 + book STM32 microcontrollers in Ethernet network in examples
Delivery date unknown
No product available!
No product available!
No product available!
No product available!
Male terminal block, angled, 9-pin. Pitch 3.5mm. Height 9.2mm. KF2EDGR
Retired
No product available!
LAUNCHING KIT FOR AVR I 51 - SELF-ASSEMBLY KIT
Retired
No product available!
Module with driver for 64x32 or 32x16 LED matrix displays. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 105020013
Retired
No product available!
Retired
No product available!
No product available!
Adafruit 659 - FLORA - Wearable electronic platform: Arduino-compatible - v2
Retired
No product available!
Orange Pi 2G-IoT is a minicomputer with a powerful ARM Cortex-A5 processor. The computer is equipped with a GSM / GPRS (2G) module, 256 MB LPDDR2 RAM, a WiFi module and a CSI camera connector, USB Host, OTG, 26 GPIO and a microSD card slot. Works with Android, Ubuntu and Debian systems
Retired
No product available!
PCB for universal 5V power supply module. AVT1895 / 5 A
Retired
No product available!
HK JST-XH 3S Wire Extension 20cm (10pcs/bag) (9736)
Retired
No product available!
LAMP BUFFER OR PICK UP AT HOME - PLATE