- Out-of-Stock

Electronics enters board games. Instead of chasing a traditional dice, build its electronic equivalent. The readout field was made using LED diodes. The microprocessor is responsible for their control. The countdown cycle is triggered after shaking the cube - its motion is detected by a special shock sensor. If the device is not used for a long time, the system goes into the off state. This prevents the battery from discharging too much.
Manufacturer transfer multisort elektronik sp. z o.o Ustronna 41 93-350 Łódź Poland dso@tme.pl
Responsible person transfer multisort elektronik sp. z o.o Ustronna 41 93-350 Łódź Poland dso@tme.pl
PCB with programmed layout for the RGB color mixer. AVT5596 A +
No product available!
No product available!
LCD 2x20, 116x37mm, FSTN NEGATIVE, LED backlight (white), enhanced temperature range, RoHS
No product available!
Assembled uncomplicated thermometer - recorder. AVT5573 C
No product available!
Dispensing needle for precise application of glue, flux with an internal diameter of 0.6mm and an external diameter of 0.89mm.
No product available!
Camera with a resolution of 0.3 MPx with a USB interface. Equipped with a CMOS OV7725 sensor with a wide-angle lens with a viewing angle of 120°. ArduCAM U6066
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
AVT kit for self-assembly of the water level indicator. AVT1949 B
No product available!
Assembled microprocessor-type clapper type acoustic switch. AVT1835 C
No product available!
Female terminal block, 4-pin. Pitch 3.5mm. Height 15.6mm. KF2EDGK
No product available!
Xmega eXploreGO module with ATXmega128A4U microcontroller (version without MP3). The module is equipped with in DataFlash memory, microSD card connector. MOD-20 / AZ
No product available!
Electronic dice - a set for self-assembly