- Out-of-Stock
830-Point Breadboard
This 6.5" x 2.125" solderless breadboard has four bus lines each spanning the length of the board, and 63 rows of pins, enough for up to nine 14-pin DIP ICs or seven 16-pin DIP ICs. The rows and columns of tie points are conveniently labeled, and multiple units can be connected for larger projects.
Note: As of September 1, 2011, this solderless breadboard has changed back to the way it was originally, with four bus lines that each span the full length of the board. The version of this breadboard we sold between April, 2011 and September, 2011 had eight bus lines that spanned half the length of the breadboard (i.e. the presently full-length bus lines were each divided into two separate halves, with a double-wide gap between these halves). Please take this change into account if you are copying a circuit from an older version of this breadboard to a newer version.
Solderless breadboards are commonly used for prototyping because they allow you to quickly build temporary circuits without soldering. Breadboards accept most through-hole parts and up to #22 wire. When you’re done or want to change your circuit, it’s easy to take your circuit apart. For best results, use solid wires when breadboarding; you’ll find pre-cut jumper wire kits and premium jumper wires especially convenient.
![]() |
![]() |
400-Point Breadboard |
![]() |
350-Piece Wire Kit with Adjustable Case |
![]() |
0.100" (2.54 mm) Breakaway Male Header: 1x40-Pin, Straight |
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
No product available!
No product available!
No product available!
No product available!
ROSA3D filament made of high-quality PET-G granules. 0.8 kg of filament with a diameter of 1.75 mm is wound on the spool. ROSA3D PET-G Standard Orange
No product available!
MYIR MYS-7Z0007S-C is a single board module based on the Xilinx XC7Z007S-1CLG400C chip (Zynq-7007S). This system consists of a single-core processor based on Cortex-A9 core, which can operate at a maximum frequency of 667 MHz and Artix-7 FPGA. The computer is equipped with 512 MB of DDR3 SDRAM, 4 GB of eMMC memory and 16 MB of QSPI Flash memory
No product available!
Assembled 6V gel battery protection. AVT1970 C
No product available!
No product available!
No product available!
No product available!
No product available!
Mini USB Bluetooth dongle compatible with ODROID-C1, C1+, C0, C2 and XU3, XU4
No product available!
No product available!
EXTREME heat shrink tubing for electrical and mechanical insulation, diameter against shrinkage 5.0 mm; diameter after shrinkage 1.5 mm, a set of 10 pieces with a length of 1 meter
No product available!
No product available!
3-pin ARK mounting strip, 5.0 mm pitch. 301-5.0-03P-12-00A(H)-GR
No product available!
No product available!
830-Point Breadboard