LCD-AC-2402A-DIW W / KK-E12 C

The AM receiver of the DCF77 signal with the MAS6180 system, allows to receive the frames of the synchronization signal from the time standard, using the carrier frequency of 77.5kHz. Thanks to this module, it is possible to create a clock with automatic date and time synchronization. The module has a ferrite antenna. modDCF77

Module with Tegra X1 SoC system containing four 64-bit ARM Cortex A57 cores and a Maxwell graphic layout consisting of 256 cores supporting CUDA technology. NVIDIA Jetson TX1

Mini module Camera Shield w/2 MP OV2640 for Arduino UNO Mega2560 board. ArduCam B0067

Arducam-F Rev.C+ Camera module shield with OV2640 for Arduino UNO MEGA2560 DUE. ArduCam B0051+B0011

Arducam-LF Rev.C+ Camera module + 3.2 inch LCD for arduino UNO MEGA2560 DUE. ArduCam B0052+B0011

Module designed for connecting more than one camera to a single CSI camera port on RPi board. One adapter board can connect 4 cameras and user can stack up max. 4 adapter boards that means up to 16 cameras on a single RPi board. ArduCAM B0069

5mp 1080p OV5647 NoIR Camera Module with M12*0.5 Mount Lens for Raspberry Pi. ArduCam B0035

OV5647 Camera Board with LS-40180 Fisheye Lens M12x0.5 Mount for Raspberry Pi 3. ArduCam B0055

Open source WIFI camera develop board based on Texas Instruments CC3200 SimpleLink WIFI IoT solution and Aptina MT9D111 camera module. ArduCAM B0073

SEN-13944

Gravity: GPIO Shield for Arduino is an I / O port expander compatible with Arduino UNO. It allows to expand the capabilities of the base board by providing a total of 36 digital and analogue pins as well as UART and I2C interfaces. DFRobot DFR0334

A highly cost-effective audio hat which fits on the GPIO of the Raspberry Pi B+/2B/3B, uses i2S interface audio solution, supports 24-bit /192KHz high quality sound, compatible with other audio equipment via RCA lotus socket, includes a built-in high fidelity headphone amplifier, where you can plug in a 3.5mm audio jack directly. DFR0449

Teensy Prop Shield is meant for making light and sound effects on small, handheld props and wearable costumes. This shield features a 2W audio amp, high-speed 5V buffers for driving APA102 LEDs, and an 8MB flash memory. PJRC PROP-SHIELD-LC

The Teensy Prop Shield is meant for making interactive light and sound effects on small, handheld props and wearable costumes. Features 10DoF (Degrees of Freedom) motion sensors, 2W audio amp, high-speed 5V buffers for driving APA102 LEDs, 8MB flash memory. DEV-13995

BOB-13752

EP09 / 16