- Out-of-Stock
Logic Level Converter
ID: 201389
BOB-08745 In Fritzing Library - Logic Level Converter
Free shipping
free shipping in Poland for all orders over 500 PLN
Same day shipping
If your payment will be credited to our account by 11:00
14 days for return
Each consumer can return the purchased goods within 14 days
BOB-08745 In Fritzing Library - Logic Level Converter
Description:
If youve ever tried to connect a 3.3V device to a 5V system, you know what a challenge it can be. The SparkFun logic level converter is a small device that safely steps down 5V signals to 3.3V and steps up 3.3V to 5V. This level converter also works with 2.8V and 1.8V devices. Each level converter has the capability of converting 4 pins on the high side to 4 pins on the low side. Two inputs and two outputs are provided for each side.Bread board friendly! Can be used with normal serial, I2C, SPI, and any other digital signal. Does not work with an analog signal.
The level converter is very easy to use. The board needs to be powered from the two voltages sources (high voltage and low voltage) that your system is using. High voltage (5V for example) to the HV pin, low voltage (2.8V for example) to LV, and ground from the system to the GND pin.
Pins are labeled as Inputs and Outputs. These are relative to the board. A digital one going into the RXI pin on the 5V side will show up on the RXO pin on the 3.3V side as 3.3V. A digital one going into the TXI pin on the 3.3V side will show up on the TXO pin on the 5V side as 5V.
Dimensions:
- 0.5x0.6"
Documents:
201389
You might also like
Available
Other products in the same category (16)
Male terminal block, angled, 2-pin. Pitch 3.81mm. Height 7mm. 15EDGRC
Retired
No product available!
The Arduino UNO WiFi board is based on the ATmega328 and it has an integrated ESP8266 WiFi Module. If you are starting out with Arduino, or starting with IoT, this is the board to get. A000133
Retired
No product available!
BPI AD/DA extend module with the PCF8591 single-chip, single-supply low-power 8-bit CMOS data acquisition device with four analog inputs, one analog output and a serial I2C-bus interface
Retired
No product available!
AVT kit for self-assembly of an extremely effective bomb clock. AVT3128 B
Retired
No product available!
Wired mouse with a precise optical sensor. It has a button to change the resolution in four levels: 800/1200/1600/2400 DPI. 1.8m cable with USB plug. Natec NMY-0667
Retired
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
Male terminal block, angled, 5-pin. Pitch 5.0mm. Height 7.8mm. 2EDGRC-5.0-5P
Retired
No product available!
No product available!
Raspberry PI 4 computer case transparent
Plastic case for Raspberry Pi 4 minicomputer, transparent. Raspberry RPI-ENC046-CLR/Mikrokontroler
Retired
No product available!
No product available!
Spring dedicated to the heating table of 3D printers. It allows you to adjust the degree of tightening the knob, and thus enables the proper leveling of the working table
Retired
No product available!
No product available!
BOB-08745 In Fritzing Library - Logic Level Converter