- Out-of-Stock
AUTOMATIC AMPLIFIER 70 W - SELF-ASSEMBLY KIT
A modern car amplifier system based on an integrated circuit that can work as a subwoofer. High output power (70 W) is obtained thanks to the use of an amplifier working in class H. It is a bridge system whose last stage is supplied from increased voltage (bootstrap). An additional advantage of the H class is higher efficiency, so the 'cube' will be less heated when full control. TDA1562 has additional internal circuits, including intelligent thermal and short-circuit protection. A special circuit ensures mute when turning the power on and off. This allows you to eliminate any clatter and transient noise.
The device is especially recommended for lovers of loud music in the car, musicians and constructors of sound equipment
Selected parameters:
Download
Manufacturer AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
Responsible person AVT SPV Sp. z o.o. Leszczynowa 11 03-197 Warszawa Poland zamowienia@avt.pl
ArduCam camera module with autofocus designed for Raspberry Pi. It was equipped with a matrix (Sony IMX219) with 8 MPix resolution and an integrated IR filter. To connect the camera with Raspberry Pi is implemented using a CSI connector. Autofocus allows sharpening in the range from 4 cm to infinity. ArduCAM B0122
No product available!
The minicomputer with the Intel Celeron J4115 quad-core processor (2.5 GHz, 64-bit) has 2 slots for DDR4 RAM modules. Additionally, it is equipped with, among others: Gigabit Ethernet, HDMI 2.0 port and Display Port 1.2 4K/60Hz, four USB sockets, 24 GPIO, PCI-e slot, two SATA3 connectors. Rev-B+. ODROID H2+
No product available!
Camera module with Sony Starvis IMX327 sensor that works with Raspberry Pi minicomputers. It has a 2 MP sensor and an 80° viewing angle lens, and is equipped with a motorized IR-CUT filter. ArduCAM B0425
No product available!
No product available!
Permanent cylindrical neodymium magnet with a diameter of 8 mm and a height of 3 mm.
No product available!
No product available!
The BQ-CC55 microprocessor charger designed for quick charging of R6/AA or R03/AAA NiMH batteries. It has 4 separate charging channels, which allows you to simultaneously charge 1, 2, 3 or 4 batteries. Panasonic BQ-CC55E
No product available!
Female terminal block, 7-pin. Pitch 3.5mm. Height 15.6mm. KF2EDGK
No product available!
No product available!
No product available!
HK 2.4Ghz 7DB Antenna for FrSky Modules (And compatible Radios/Modules) (20108)
No product available!
No product available!
No product available!
No product available!
No product available!
No product available!
AUTOMATIC AMPLIFIER 70 W - SELF-ASSEMBLY KIT