TE0790-03 - XMOD FTDI JTAG adapter (Xilinx compatible)

Name: TE0790-03 - XMOD FTDI JTAG adapter (Xilinx compatible)
Brand: Trenz electronic GmbH
SKU: 577317

ID: 577317

Universal USB2.0 adapter for JTAG, UART and GPIO based on the FTDI FT2232H chip. The adapter card converts signals from USB2.0 to standard serial or parallel interfaces of embedded systems such as JTAG, SPI, I²C and UART. Compatible with Xilinx tools. Trenz TE0790-03

Retired

Description

The module is equipped with a programmable CPLD system controller supplied by Lattice XO2-256 CPLD to control the signals of configured interfaces. The USB 2.0 data stream can also be converted to 8 independent GPIOs or used as FIFO.

EEPROM is pre-programmed and recognized by all Xilinx tools (ISE / Impact / Chipscope, Vivado Programmer / SDK).

Features

FT2232H
- RX / TX channel LEDs
- Mini USB connector (no cable included)
- 93C56 EEPROM
Lattice XO2-256 CPLD
- Programmable with Lattice tools
- 8 universal I / O pins
- VCCIO or 3.3 V or supplied by the user (1.8 to 3.3 V)
Red user LED
12 MHz clock with oscillator
DC / DC step down converter for USB power supply
Green power LED
User Button
4-position DIP switch
- Selecting the CPLD program mode
- Disabling FTDI EEPROM
- VIO as VCC
- VCC with USB
Dimensions: 20 x 25 mm
M3 mounting holes

Reference 577317

Wiki resources

Manufacturer

Responsible person

modJTAG - JTAG connector adapter module

Adapter for 20/14/10-pin JTAG. It allows to connect the JTAG programmer to a evaluation boards which uses various standards of the programming connector. IDC20, IDC14, IDC10 and JST-XH sockets are available.

zł10.22

24h

Available quantity: 6

Available

JTAG Isolator

JTAG interface galvanic separator that protects equipment against damage caused by potential differences, with a maximum clock frequency of 110 MHz, 3-5 V power supply, and isolation voltage up to 1 kVDC, equipped with multiple connectors and optical status signaling

zł399.00

24h

Available quantity: 33

Available