.png)
- Out-of-Stock
2.13" 3-color E-Ink e-Paper display (C) 212x104 - Waveshare 14186
ID: 582591
3-color e-Paper display with a diagonal of 2.13" and a resolution of 212x104 px. SPI interface. No PCB. Waveshare 2.13inch e-Paper (C)
Description
3-color e-Paper display with a diagonal of 2.13" and a resolution of 212x104 px. It has the ability to display content with a two-level gray scale, and the built-in controller communicates via the SPI interface. E-Paper displays are characterized by high contrast of the displayed image and consume electricity only when the displayed content is changed It is compatible with 3.3V systems. Support is available on the product page in the form of examples of use with Raspberry Pi, Jetson Nano, Arduino and STM32.
Features
- Diagonal: 2.13"
- Resolution: 212x104 px
- Display color: yellow, black, white
- Gray levels: 2
- Interface: 3-wire SPI, 4-wire SPI
- Pixel size: 0.229 x 0.228
- Full refresh time: 15 seconds
- Power consumption: 26.4 mW
- Viewing angle:> 170 °
- No backlight, display the last content after power off
- Low energy consumption
- Working voltage: 3.3V
- Display size: 23.71 x 48.55 mm
- Outline Size: 29.2 x 59.2 x 0.98mm
582591
Data sheet
- Screen type
- E-Ink/Epaper
- Diagonal (inch)
- 2,13
- Resolution
- 212 x 104 px
- Interface
- SPI
- Touch
- No
Manufacturer
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
Responsible person
- BTC Korporacja sp. z o. o.
- Ludwinowo Zegrzyńskie 52G
- 05-140 Ludwinowo Zegrzyńskie
- Poland
- [email protected]
- 22 767 36 20
You might also like
Driver for EPAPIER displays in the form of a HAT overlay for Raspberry Pi computers. The SPI interface is used for communication with the controller. Waveshare e-Paper Driver HAT
zł37.76
24h
Available quantity: 4
Available
Black and white e-Paper display with a diagonal of 2.13" and a resolution of 250x122 px. SPI interface. Without PCB. Waveshare 2.13inch e-Paper
zł36.26
24h
Available quantity: 4
Available
Module with e-Paper display, 2.13" diagonal and 212x104 px resolution. Communication via SPI interface. Waveshare 2.13inch e-Paper HAT (B)
zł63.14
24h
Available quantity: 1
Available
3-color e-Paper display with a diagonal of 2.13" and a resolution of 212x104 px. SPI interface. No PCB. Waveshare 2.13inch e-Paper (B)
zł33.49
24h
Available quantity: 4
Available
Other products in the same category (16)
A small evaluation board with the nRF52840 (ARM Cortex-M4) system designed for projects related to Mesh networks. Adafruit 3999
Retired
No product available!
Orange Pi 3 1GB is a mini-computer equipped with SoC Allwinner H6 (quad-core, frequency up to 1.8 GHz, 64-bit architecture, ARM Cortex ™ -A53 core). It has 1GB RAM (LPDDR3), Mali T720 graphics chip, 8GB eMMC memory. The board can run Android 7.0 and Linux.
Retired
No product available!
Orange Pi 3 2GB for minicomputer equipped with SoC Allwinner H6 (quad-core, frequency up to 1.8 GHz, 64-bit architecture, ARM Cortex ™ -A53 core). It has 2 GB of RAM (LPDDR3), a Mali T720 graphics chip, 8 GB of eMMC memory. The board can run Android 7.0 and Linux.
Retired
No product available!
Module with a UV ultraviolet light sensor VEML6075. Enables measurement of the level of UVA (320-400nm) and UVB (280-320nm) radiation. It communicates via the I2C bus. SparkFun SEN-15089
Retired
No product available!
SanDisk Extreme microSDHC memory card with a capacity of 32GB, maximum reading speed up to 100 MB / s, U3 UHD class
Retired
No product available!
SanDisk Extreme microSDXC memory card with a capacity of 64GB, maximum read speed up to 160 MB / s, Class 10, U3, V30
Retired
No product available!
SanDisk Ultra microSDXC memory card with a capacity of 64GB, maximum reading speed up to 80MB / s, Class 10 UHS-I
Retired
No product available!
SanDisk Ultra microSDHC memory card with a capacity of 16GB, maximum reading speed up to 80MB / s, Class 10 UHS-I
Retired
No product available!
No product available!
FPGA Evaluation Kit based on the XC7A50T-1CSG324C chip from the Artix-7 FPGA Xilinx family. Nexys works with Xilinx ISE and Vivado software. Equipped with numerous interfaces and sensors allows you to develop projects without attaching additional elements to the set. Digilent 410-292-1
Retired
No product available!
FPGA Evaluation Kit based on the XC7A50T-1CSG324C chip from the Artix-7 FPGA Xilinx family. Nexys works with Xilinx ISE and Vivado software . Equipped with numerous interfaces and sensors allows you to develop projects without attaching additional elements to the set. Digilent 410-292-1
Retired
No product available!
FPGA Evaluation Kit based on the XC7A100T-1CSG324C chip from the Artix-7 FPGA Xilinx family. Nexys works with Xilinx ISE and Vivado software . Equipped with numerous interfaces and sensors allows you to develop projects without attaching additional elements to the set. Digilent 410-292
Retired
No product available!
FPGA Evaluation Kit based on the XC7A100T-1CSG324C chip from the Artix-7 FPGA Xilinx family. Nexys works with Xilinx ISE and Vivado software . Equipped with numerous interfaces and sensors allows you to develop projects without attaching additional elements to the set. Digilent 410-292
Retired
No product available!
The UT204 clamp meter is designed for measuring AC and DC current, AC and DC voltage, resistance and frequency. It is equipped with a relative measurement function, Hold function, True RSM and automatic range change. Uni-T UT203
Retired
No product available!
No product available!
The eMMC 5.1 flash memory module for Hardkernel Odroid XU4 computers. 8 GB capacity, installed Linux operating system. The set includes a microSD adapter. Hardkernel
Retired
No product available!
3-color e-Paper display with a diagonal of 2.13" and a resolution of 212x104 px. SPI interface. No PCB. Waveshare 2.13inch e-Paper (C)