Category: RETIRED PRODUCTS

The resistance meter allows you to measure low resistance values from 120 mΩ with a resolution of 10 uΩ. It is used to measure small DC resistances with the 4-wire method. Equipped with a USB interface and Li-Ion battery. Uni-T UT620A

Thermal imaging camera with a 2.4" LCD display. It measures the temperature in the range from -10 to 400°C. Uni-T UTi80P

Polyester braid for organizing numerous cables into bundles. Z28416

Polyester braid for organizing numerous cables into bundles. Z28417

Polyester braid for organizing numerous cables into bundles. Z28415

The special construction of the braid facilitates installation in all conditions. z28419

Camera module with a resolution of 13 MP equipped with an image sensor AR1335. The camera has a FoV 100° lens with M12 mount. ArduCAM B0245

Handheld thermal imaging camera with a 3.2" LCD display. It measures the temperature in the range from -20 to 300°C with an accuracy of 2°C. HTI HT-19

Adapter for connecting a Raspberry Pi to the OM-SE050ARD development board. It allows you to run the EdgeLock SE050 application on a Raspberry Pi. NXP OM-SE050RPI

HDMI to CSI-2 bridge module based on TC358840 chip. It has a 22-pin FPC connector with a pitch of 0.5 mm and an audio connector. The input signal is supplied through the HDMI connector. Auvidea 70511

LPC55S69JEV98K, ARM Cortex-M33 Microcontroller, 32 bit, 150 MHz, 640 KB Flash, VFBGA98

USB - CAN converter module. It allows the device to be connected to a computer (USB) or microcontroller (UART) via the CAN bus. USB CAN CONVERTER (UCCB)

Set with HQ camera, HDMI adapter, lens, tripod and Jetvariety adapter. Kit designed for NVIDIA Jetson Nano. ArduCAM B0243

A minisumo robot on a tracked chassis with Pololu 100:1 HP motors. Fully assembled robot, additionally requires four AA batteries. Pololu 3127

A module that allows you to connect ArduCAM cameras with a CSI interface to a PC or minicomputers via the USB3.0 interface. It not only supports high-resolution, high-frame rate image sensors, but also a stereoscopic camera and IRCUT control functions. ArduCAM B0111

A small minicomputer with a RockChip RK3328 quad-core SoC chip (ARM Cortex-A53). The computer is equipped with 2 GB DDR4 RAM, Gigabit Ethernet port and USB 3.0. Each module has its own unique MAC address. NanoPi NEO3 2GB

White case for the NanoPi NEO3 minicomputer. It allows easy access to the Ethernet connector, USB, microSD cards and the power connector. FriendlyELEC Case for NEO3

Image capture module for Raspberry Pi. Captures high definition video from digital (HDMI/DVI), analog (YPbPr component) and computer (RGB) sources in 480p, 720p and 1080p. Picapture HD1

The evaluation kit is equipped with the Lattice iCE40 HX FPGA chip. The kit is supported by iCEcube2 and Verilog and Lucid languages. SparkFun DEV-16526

Case dedicated to minicomputers Cubieboard and Cubieboard 2. Cubieboard Deluxe Case