Category: STARTER KITS, PROGRAMMERS, MODULES

Gravity: IO Expansion & Motor Driver Shield is an Arduino compatible expansion board that provides digital I / O ports, analog I2C, SPI and UART interfaces, as well as a DC motor driver. DFRobot DFR0502

STM32MP135 Discovery Kit with STM32MP135 microprocessor. It is designed to allow users to easily create applications using the STM32 MPU OpenSTLinux Distribution software. STMicroelectronics STM32MP135F-DK

Single board computer with SOM module NXP i.MX 8M processor, has 1 GB of RAM, 8GB of eMMC memory, wireless communication and TPU coprocessor. It includes numerous connectors, including USB 2.0 / 3.0 ports, DSI interface, CSI-2, Ethernet port, audio connectors and a 40-pin GPIO connector. Coral Dev Board G950-01455-01

Water pressure sensor with 3-pin Gravity interface. It enables the measurement of liquid pressure in the range from 0 to 1.6 MPa. It is supplied with the voltage of 5 V and has a linear output voltage from 0.5 to 4.5 V. DFRobot SEN0257

Module with proximity and ambient light sensor based on the VCNL4020 system. It allows you to detect obstacles in the range from 0 to 20 cm and measure light intensity from 0.26 to 16,000 lux. It communicates via the I2C bus. Adafruit 5810

I2C BME680 Environmental Sensor is a gas, pressure, temperature and humidity sensor in one MEMS housing. The module is supplied with 3.3-5V, for communication the I2C or SPI interface is used. DFRobot SEN0248

Gravity: Digital Peristaltic Pump is a peristaltic pump with a controller and a connector compatible with modeling servos. The set is powered by 5 ... 6 V. DFRobot DFR0523

Adapter designed for micro:bit educational modules. It facilitates access to all pins, which are led out on the connector with a raster of 2.54 mm, which allows the use of a breadboard. SB Components 14880

Module with a button, LED diode and a blue cap. DFRobot DFR0029-B

Module with 5 A 250 VAC relay. DFRobot DFR0017

Fan module with DC motor, propeller and connection cable. DFRobot DFR0332

Module with 16-bit AD5693R DAC converter with built-in EEPROM memory. Equipped with a STEMMA QT connector, it communicates using the I2C bus. Adafruit 5811

8-digit, 8-segment LED display module with 16-level brightness adjustment. Communication via the I2C interface. DFRobot DFR0646-G

Module with a button, LED diode and a white cap. DFRobot DFR0029-W

The base plate is dedicated to the RP2040 Stamp module. It allows you to easily prototype devices based on RP2040. Pimoroni SP012

Module with a 4-element 14-segment display. The board is equipped with a Qwiic connector and communicates via the I2C interface. SparkFun COM-16918

M5Stack series development board equipped with ESP32-S3 WiFi module. It will work well in projects related to IoT, as a STEM educational module or in Smart Home devices. M5Stack S007

Radio receiver module operating at 433 MHz. It is equipped with Gravity connectors and communicates via a digital interface. DFRobot TEL0142

Gravity: Vibration Motor Module is a module with a small vibration motor powered by 5V voltage, controlled by a binary signal (high / low state) or using a PWM signal. DFRobot DFR0440