DFRobot module with relay. The relay coil is supplied with 5 V voltage. The relay activation time is 10 ms.
Data sheet
Manufacturer
Responsible person
ModRL01 module with 10A/250VAC (10A/24VDC) relay, supply of 5 V load relay coil, additional control circuit, protected overvoltage control
Expansion board for Arduino, allows easy connection of XBee modules, has separate outputs for I2C, SPI and UART buses. The built-in 3.3V voltage stabilizer and operating mode switch make it easier to program the Arduino when the XBee module is connected to the sockets. DFRobot DFR0265
A small module with a PIR motion sensor. It allows detecting movement within a maximum range of 6 meters (default up to 3 meters). The measuring angle is 120 degrees. The module has a connector in accordance with the Grove standard. Seeed Studio 101020020
The module with the tilt sensor, the sensor output is a digital signal. The module has a connector in accordance with the Grove standard. Seeed studio 101020025
The touch sensor module (touch button) can be used as a replacement for traditional mechanical buttons. It operates based on the TTP223-B system, which measures the capacity of the metal field on the module. The module has a connector in accordance with the Grove standard. Seeed studio 101020037
Module with a magnetic sensor based on the CT10 reed switch. CT10 is a unipolar reed switch, normally open. The sensor reacts to the action of an electromagnet, permanent magnet or a combination thereof. The module has a connector in accordance with the Grove standard. Seeedstudio 101020038
No product available!
The Hall sensor module allows magnetic field detection, can be used to measure angle of rotation, displacement, mechanical vibrations, etc. The module has a connector in accordance with the Grove standard. Seeed studio 101020046
Module with a flame sensor or other light sources with a wavelength in the range of 760 to 1100 nm. It was based on the YG1006 sensor (photovolver NPN). The sensor has a connector compatible with the Grove standard. Seeed studio 101020049
The kit includes a control module (with ETA1617 and NE555) and an ultrasonic transducer. The water atomiser module allows for the construction of, for example, a small humidifier. The module has a connector in accordance with the Grove standard. Seeed studio 101020090
Module with RGB LED, it is possible to control individual colors using digital signals as well as PWM signals. The module has a connector in accordance with the Grove standard. Seeed studio 101020472
Module with red LED diode and potentiometer. The board is equipped with a Grove connector and communicates via a digital interface. Seeed Studio 104030005
Grove module with a small vibration motor. Seeed studio 105020003
No product available!
Module with an active buzzer. The board is equipped with a Grove connector and is controlled by a digital signal. Seeed Studio 107020000
Module with LM386 audio amplifier and loudspeaker. The board is equipped with a Grove connector and is controlled by a PWM signal. Seeed Studio 107020001
Module with a 3-axis MMA7660FC accelerometer with a measuring range up to ± 1.5g. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020039
Module with a gesture sensor PAJ7620U2, which allows to recognize up to 13 gestures. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 101020083
No product available!
Module with OLED 0.96" display with a resolution of 128x64 px. The board is equipped with a Grove connector and communicates via the I2C interface. Seeed Studio 104030008
Module with pressure and temperature sensor BMP280. The board is equipped with a Grove connector and communicates via the I2C or SPI interface. Seeed Studio 101020192
Module with 5 A 250 VAC relay. DFRobot DFR0017