modRL04

Module with 4 relays 12 V with a maximum switching current of 7 A. Numato Lab RL40002

Module with 5V relay and timer. It allows the implementation of delayed switching on or off of the circuit with adjustable time in the range from 1 s to 100 s and from 1 s to 15 min.

4 route MOSFET switch module V2.0, IRF540, RoHS

The module is equipped with four 10A / 250VAC relays controlled independently via a serial bus (UART) or from a PC (through a microUSB connector). The NO / NC contacts of the relays have been led to the ARK screw terminals. ICSTATION ICSE012A

Module with 2 SSR relays with a load of up to 3 A. The board is equipped with the ULN2003 system and communicates via a digital interface. Numato Lab SSRC20001-DC

Industrial module with Ethernet interface that allows control of 8 relays via RJ45 port and has 8 built-in digital inputs. It uses Modbus TCP protocol, PoE (Power over Ethernet) power supply and is equipped with a rail-mounted housing. Waveshare Modbus POE ETH Relay (B)

A magnetic latching relay that features low power consumption and quiet operation. It allows switching of signals up to 36 V and 10 A. It remains in the last position it was in before power was lost. DFRobot DFR0996

Module with SSR relay with a load of up to 3 A. It communicates via the USB interface and does not require additional power supply. Numato Lab SSRP20001-AC

AO3406 MOSFET transistor module with N channel and JST PH2.0 connector designed to control motor, solenoid or LEDs. Adafruit 5648

Module with 2 SSR relays with a load of up to 3 A. The board is equipped with the ULN2003 system and communicates via a digital interface. Numato Lab SSRC20001-AC

Module with eight 240V/2A relays controlled by 5V with a fuse triggered by a low state. modSSR-8CH-L

Industrial module with 8 relays. It communicates via RS485 interface and supports Modbus RTU protocol. Waveshare Modbus RTU Relay (EN)

Module with 4 SSR relays with a load of up to 3 A. The board communicates via the Ethernet interface. Numato Lab 4ETHSSR001-DC

The module with the relay is designed for the M5Stack sets. It allows you to control devices with a working voltage of up to 220 V AC and a current of up to 3 A or a voltage of 30 V DC and an intensity of 3 A. M5Stack U023

Module with 8 relays 24 V with a maximum switching current of 7 A. Communicates via the USB interface. Numato Lab RL80001-24

Switch module with a maximum voltage of 12 V and a current of 10 A based on a MOSFET transistor, controlled by a digital pin. It is equipped with a screw connection and a status LED. SparkFun SPX-19799