SEN-13582

The shield provides the standard MIDI port circuits, incl. 5-pin DIN connectors, pto-isolated MIDI input, LEDs on D6 and D7, pushbuttons on D2, D3 and D4, and rotary potentiometers on A0 and A1. DEV-12898

The Microchip system in the DIP8 housing, a dual driver, allows the MOSFET transistors to be controlled with a high switching speed. The controller is characterized by low power consumption, high current efficiency when loading eg gate capacity, or ESD resistance up to 4kV

INEMO system: 3D accelerometer and 3D gyroscope in LGA16L housing, made by STMicroelectronics. Allows measurement of acceleration up to 16g and angular velocity up to 2000 degrees / second, communication takes place on the I2C / SPI bus

Tilt Sensor

A small USB 2.0 hub that allows you to disable individual devices connected to its USB ports, as well as a visual evaluation of the number of devices enabled. It has a built-in connector for the external power supply, so it can act as an active hub. Cable with a length of 40cm, 4 USB ports

Bluetooth 2.1+EDR module for mounting in SMD technology with a fully configurable UART interface (transfer speed up to 2 Mb/s). SparkFun WRL-12575

Sewable with a 3-pin JST wiring adapter with 3 holes on the board perfect for conductive thread or soldering, wired to a single 3-pin JST-PH Adapter. Sdafruit 2566

GPS-13740

Dual Full-Bridge Driver, Power SO20, STM, RoHS

The compact (0.4″ × 0.5″) D24V5F2 synchronous buck voltage regulator takes input voltages between 3 V and 36 V and efficiently reduces them to 2.5 V while allowing for a maximum output current of 500 mA. This regulator offers typical efficiencies between 80% and 90%. The pins have a 0.1″ spacing, making this board compatible with standard solderless breadboards and perfboards.

The compact (0.4″ × 0.5″) D24V5F9 synchronous buck voltage regulator takes an input voltage of up to 36 V and efficiently reduces it to 9 V while allowing for a maximum output current of 500 mA. Pololu 2845

This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 9 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.

This small synchronous switching step-down (or buck) regulator takes an input voltage of up to 38 V and efficiently reduces it to 6 V. The board measures only 0.7″ × 0.7″, but it allows a typical continuous output current of up to 2.5 A. Typical efficiencies of 85% to 95% make this regulator well suited for powering moderate loads like sensors or small motors.

Pololu 2834

Pololu 2832

The module allows measuring the light around the sensor. The measuring range is in the range 1 - 65535 LUX, and communication takes place using the I2C bus. modBH1750 (GY-302)

Touch screen (capacitive panel) 2.8 "(320 x 240 pixels) designed for Raspberry Pi A / B. The display is controlled by the SPI interface. Adafruit 1983

modTSL2561 is a module containing a light sensor TSL2561; communication with the system takes place using the I2C bus