Arduino and Breadboard Holder. DEV-11235

DC-DC Step-Down converter module. It has an input voltage from 7.5 to 45 V, an output voltage of 7.5 V and a maximum output current of up to 3 A. Pololu 4894

DRV8825 Stepper Motor Driver Module for Arduino. It allows you to control two drives, equipped with an XBee connector. DFRobot DRI0023

Shielded FTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCF6-10CC-0500-R

A 1.54-inch white OLED display that allows you to display basic graphics and text. It has a resolution of 128 x 64 pixels and communicates via the SPI or I2C interface. Waveshare 1.54inch OLED Module

Step-Down converter with input voltage up to 36 V which effectively reduces it to 3.3 V, while maintaining current up to 500 mA. Pololu 2842

Module with a thermal imaging camera with an 80x42 field matrix and a 45° viewing angle. Communicates via USB interface. Waveshare Thermal USB Camera

Adafruit 1126 - Sewable Snaps - 5mm Diameter - Card of 24

IPS LCD display with a diagonal of 7.9" with built-in Hi-Fi speakers. It is equipped with an HDMI interface and offers a resolution of 400 x 1280 pixels. Waveshare 7.9inch Side Monitor

Module with an IPS LCD display with a diagonal of 7" and a resolution of 1024x600 pixels dedicated to Raspberry Pi Pico boards. It uses the DVI interface for communication. Waveshare PICO-DVI-7inch

Module with an IPS LCD display with a diagonal of 10.1" and a resolution of 1024x600 pixels dedicated to Raspberry Pi Pico boards. It uses the DVI interface for communication. Waveshare PICO-DVI-10.1inch

ARM Cortex-M4, Kinetis K20 Family, DSP, 512kB Flash, LQFP144, Freescale, RoHS

This is a simple to use motion sensor. Power it up and wait 1-2 seconds for the sensor to get a snapshot of the still room. This unit works great from 5 to 12V (datasheet shows 12V). You can also install a jumper wire past the 5V regulator on board to make this unit work at 3.3V. Sensor uses 1.6mA@3.3V. SEN-13285

LM35 analog temperature sensor module for Arduino. DFRobot DFR0023

This disc load cell (sometimes called a strain gauge) can translate up to a whopping 200kg of pressure (force) into an electrical signal. Each load cell is able to measure the electrical resistance that changes in response to, and proportional of, the strain (e.g. pressure or force) applied to the disc. SEN-13332

DFRobot (FIT0004)

Module with a 4-color e-Paper display with a diagonal of 2.36" and a resolution of 296x168 px. It communicates via the SPI interface. Waveshare 2.36inch e-Paper Module (G)

Adafruit 831 - EL Wire 6V Sound Activated Pocket Inverter

Tic T500 USB Multi-Interface Stepper Motor Controller