Adapter from BNC male connector to terminal spring connector

Module with MLX90615 temperature sensor with a measurement accuracy of 1°C and a resolution of 0.02°C. It communicates via the UART interface

A module with a joystick designed for M5Stack sets. Returns data from two axes and button state via the I2C interface. M5Stack U024-C

Adapter from male RCA connector to terminal spring connector

Module with a capacitive fingerprint reader with UART and USB interface. Waveshare Capacitive Fingerprint Reader (B)

RGB LED matrix display with a resolution of 64x32 (2048 LED) for Raspberry Pi Pico. Equipped with RTC clock, light sensor, buzzer and IR receiver. Waveshare Pico-RGB-Matrix-P3-64x32

The module is equipped with a button. It communicates via a digital interface and allows you to add simple controls to your M5Stack based project. M5Stack Button Unit

A set of adapters dedicated to the XGecu T56 universal memory programmer. Enable memory support in BGA48, BGA63, TSOP56, SOP56 and EMMC153/160 package

Adapter dedicated to the XGecu T56 universal memory programmer. Allows memory support in the BGA64 package

NFC reader with USB interface. It allows you to easily read data from an NFC/RFID card using a computer

Zynq-7000 All Programmable SoC, Dual ARM Cortex-A9 MPCore, Artix-7 FPGA, 28K Logic Cells, 667MHz CSPBGA400, Xilinx

FRAM chip has 64 Kbits (8 KBytes) of storage, interfaces using SPI, and can run at up to 20MHz SPI clock rates. Each byte can be read and written instantaneously (like SRAM) but will keep the memory for 95 years at room temperature. Adafruit 1897

Adapter dedicated to the universal TL866II Plus memory programmer. It enables memory support in the TSOP32, TSOP40 and TSOP48 package

TDA7393, 2x32W Dual bridge audio car amplifier, MULTIWATT15

The module is equipped with four 10A / 250VAC relays controlled independently via a serial bus (UART) or from a PC (through a microUSB connector). The NO / NC contacts of the relays have been led to the ARK screw terminals. ICSTATION ICSE012A

LCD panel with the possibility of controlling its transparency. Can block up to about 95% of incident light. Adafruit 3330

Camera with OV7670 CMOS sensor with a resolution of 640x480 px. It communicates via a parallel interface. ArduCAM M0030

ToF distance sensor (Time of flight) with a range of up to 60 cm. The module is powered with the voltage of 3.3 V and communicates via the I2C interface. DFRobot SEN0429

Compact ORP monitoring system used as an indicator of water quality detection. DFRobot SEN0464

Module with a color LCD TFT display with a diagonal of 0.96" and a resolution of 160x80 pixels. It uses the ST7735 controller and communicates via the SPI interface. DFRobot DFR0847