The FINDER 8-pin DIN rail relay socket is an ideal solution for the 40.51, 40.52, 40.61, 44.52 and 44.62 series relays, offering reliability and a wide operating temperature range. Finder 95.75 SMA

The module with the EEPROM 24LC256 memory chip with a capacity of 32 kB. It is supplied with the voltage ranging from 2.5 V to 5.5 V and communicates via the I2C interface (Gravity connector). DFRobot DFR0117

Antenna with built-in LNA amplifier with high sensitivity, for mounting in a device using a GPS module. The antenna has a 75mm cable, terminated with a U.FL plug (IPEX). Dimensions of the device: 25 x 25 x 4 mm

Male terminal block, angled, 9-pin. Pitch 3.81mm. Height 7mm. 15EDGRC. Set of 5 pieces

Camera with a resolution of 8 MPx with a USB interface. Equipped with a CMOS IMX219 sensor with a lens with a viewing angle of 60° and an autofocus function. ArduCAM B0292

The module with the UART-RS485 converter is designed to work with the Raspberry Pi Pico. It has a built-in SP3485 chip and enables data transmission between the UART interface and the RS485 device. Waveshare Pico-2CH-RS485

A4988 Stepper Motor Driver Carrier with Voltage Regulators

Module with eight 240V/2A relays controlled by 5V with a fuse triggered by a low state. modSSR-8CH-L

1.8-meter USB 2.0 cable that allows you to connect devices with USB A connectors. Often used as a USB extension cable for power and data transmission between devices. Akyga AK-USB-07

Single-color LED strip driver. It allows you to control strips with LEDs powered with voltage from 12 to 24 V using built-in buttons

Kinetis L Series Cortex-M0+, 32bit MCU, 64kB Flash, LQFP80, Freescale, RoHS

Air530Z GPS module with external antenna. The board is equipped with a Grove connector and communicates via the UART interface. Seeed Studio 109020022

A 10 mm diameter indicator lamp is supplied with 12 V DC. Orange color. XD10-3

Kinetis L Series Cortex-M0+, 32bit MCU, 128kB Flash, QFN48, Freescale, RoHS

UART - Ethernet converter enabling two-way communication between devices equipped with UART TTL ports and the Ethernet network. It is visible in the system as a virtual COM port and configured via the website or using AT commands. USR-TCP232-S2

Kinetis L Series Cortex-M0+, 32bit MCU, 32kB Flash, LQFP64, Freescale, RoHS

Stepper motor driver that can work with a voltage in the range from 20 to 50 V and a maximum current of 4.2 A. It allows you to configure the microstep in the range from 2 to 128. DM542

Kinetis L Series Cortex-M0+, 32bit MCU, 128kB Flash, QFN32, Freescale, RoHS

Module with a passive buzzer. The board is equipped with an XH2.54 connector and is controlled by a PWM signal