Module with BME280 environmental sensor. It allows you to measure temperature, humidity and pressure. The sensor is equipped with two communication interfaces: SPI and I2C (Qwiic). SparkFun SEN-15440

GPS module with 72-channel GNSS ZOE-M8Q receiver. The system can receive data from all major positioning systems: GPS, GLONASS, Galileo and BeiDou. It has UART and I2C interfaces. SparkFun GPS-15193

Module with a capacitive touch sensor based on the CAP1203 chip. There are three touch panels on the board that can be used as separate sensors (pins CS1, CS2, CS3) or as a touch slider. I2C communication. SparkFun SEN-15344

Power module with a USB Type-C connector based on the STUSB4500 system. It enables powering devices with voltages ranging from 5 V to 20 V and currents up to 5 A. Configuration via the I2C interface. SparkFun DEV-15801

Adafruit 2226

Real time clock (RTC) module. It allows you to read data about the date and time. Communication with the module takes place via the I2C interface. SparkFun BOB-16281

66 channel GPS receiver module LS20031. It communicates via the UART TTL interface with a refresh rate of up to 10 Hz. Pololu 2138

The remotely controlled modulation module MOD-34 / AZ allows wireless load control with up to 10 A current consumption via a relay. It does not contain nRF24l01.

1m USB A-microB USB cable, white-blue cable, flat red plugs illuminated with RGB diode

Waterproof NeoPixel tape with RGB LED diodes with a length of 2 m, 60 LEDs per meter, diodes are mounted on an elastic PCB in black. Adafruit 1376

Adafruit 2340

Development kit with SAMD21G18A microcontroller with ARM Cortex M0+ core and LoRa RFM95W radio communication module. SparkFun WRL-15836

Development kit with XBee3 Micro radio module. Provides plug and play 802.15.4 2.4 GHz wireless connection (Zigbee 3.0 protocol). SparkFun WRL-15435

Development kit with XBee3 Micro radio module. Provides plug and play 802.15.4 2.4 GHz wireless connection (Zigbee 3.0 protocol). SparkFun WRL-15454

The adapter allows you to connect a device with USB type C slot to the HDMI port. LANBERG

HDMI cable compliant with the HDMI Premium High Speed with Ethernet specification, allows you transmit a 4k resolution image at 60 Hz, 1 m cable length. Lanberg CA-HDMI-20CU-0010-BK

Small size driver module TB67S279FTG stepper motor powered with 10 ... 47V voltage and working current 1.1A. The controller allows you to control the motor movement up to 7 different resolutions (up to 1/32 of a step). Polol 3098

A set with a temperature sensor based on the DS18B20 system in the form of a waterproof measuring probe, a sensor adapter and a cable. Communication via the 1-Wire interface. DFRobot KIT0021

Module with 16 QTRX type optocoupler with analog output. The module operates from 2.9 V to 5.5 V, detects objects at a distance of up to 50 mm. The sensor will be used in projects that require detection of changes in the ground, e.g. in linefollower robots. Pololu 4456

STSPIN220 stepper motor driver module with a low voltage range of 1.8...10V and 1.1A working current. The controller allows you to control the motor motion up to 9 different resolutions (up to 1/256 steps). Pololu 2877