PRT-14417

Qwiic Cable - 500mm

Measurement module for dissolved oxygen in water. It allows you to determine the level of water quality. The set includes a measuring module and a probe. DFRobot SEN0237-A

Module with a VOC sensor (volatile organic compounds) made in MEMS technology. It allows gas detection in the range of 5 to 500 ppm and has an analog output. DFRobot SEN0566

LAN9500A-ABZJ, LAN950x USB 2.0 to 10/100 Ethernet Controller, QFN56

Set of unshielded RJ-45 cat.6 network plugs. They are equipped with triple teeth, which allows them to be used with both wire and stranded cables. Additionally, each plug in the set has a guide to facilitate proper cable laying before connecting. Lanberg PLU-6000

Powerful DC motor driver. It allows you to control a motor with a power supply voltage in the range of 6 ... 28 V, the motor can draw current of 100 A (using a heat sink). For the control PWM modeling (eg from RC receivers) is used in robotics, small electric vehicles or wherever there is a need to control a DC motor. Digilent 410-334-1

7" IPS LCD display with a touch panel. Equipped with a DSI interface for displaying the image and I2C for operating the touch panel. It has a resolution of 800x480 px. Included with the housing. Waveshare 7inch DSI LCD (B) (with case A)

MP3202DJ, 1.3A Fixed Frequency  White LED Driver, TSOT-23-6

Module with a single-purpose LiPo charger and Step-Up converter with an output voltage of 5 V and current efficiency up to 1 A. SparkFun PRT-14380

8-bit voltage level converter with TXB0108 integrated circuit. It acts as a bridge between applications with different source voltages and input and output voltage levels. SB Components 21772

Module with LoRa transmitter based on RFM95 (SX1276 LoRa®). It works with a frequency of 433 MHz, maximum power up to 100 mW and a power gain of up to + 20dBm. The module has a built-in antenna, but it is possible to connect an external antenna (MHF connector). The module has a connector in accordance with the Grove standard. Seeed studio 113060007

Industrial module with 32 relays. It uses communication via the RS485 interface and supports the Modbus RTU protocol. Waveshare Modbus RTU Relay 32CH

USB port isolator based on ADUM3160 chip. It has a built-in galvanically separated voltage converter and is powered from the USB port

LiDAR CS20 3D TOF equipped with a ToF image sensor with a resolution of 640 x 480 pixels. It uses ToF technology to record three-dimensional information about objects and space. It can accurately measure distances up to 5 m. DFRobot SEN0579

GPS module with u-blox ZED-F9R system. It uses Automotive Dead Reckoning (ADR) technology. It provides highly accurate and continuous positioning by combining the 3D IMU sensor, vehicle dynamics model, correction data and GNSS measurements. SparkFun GPS-22660

A module with a temperature sensor based on the absorption of infrared radiation. Enables non-contact measurement. modTMP006

Integrated circuit - temperature sensor; working temperature from -40 to 100 ° C; TO92; THT, STMicroelectronics. Accuracy ± 1 ° C

The module with the four-bit logic translator TXB0104, can work in both directions. Connections using standard goldpin connectors with 2.54 mm pitch. It is compatible with BOB-11771

Pin header, 20 pin, 2,54mm