Module with a 3-axis accelerometer that allows you to measure acceleration in the range of ±16g with a resolution of 13 bits. It communicates via the SPI or I2C interface

Module with an analog TEMT6000 light intensity sensor. The output voltage increases with the intensity of the incident light. The sensor is powered with the voltage of 5 V

ToF distance sensor module with a range of 5 to 180 cm. Communication via UART or I2C.

Air humidity and temperature sensor with 1-Wire interface.

The Crowtail-Water Sensor 2.0 module enables detection of contact with water in digital systems. It is used in rain sensors, leak detection and overflow protection of tanks.

Module with an analog TEMT6000 light intensity sensor. The output voltage is linearly correlated with the intensity of the incident light. The module is supplied with the voltage from 3.3 to 5V

Module with the MQ3 analog alcohol sensor. It allows you to detect gas and build a simple breathalyzer. The module is powered by 5 V and has an analog output

HLK-LD2410C is a 24 GHz radar sensor for human presence and micro-motion detection, featuring UART and BLE interface. modHLK-LD2410C

The module with an alcohol sensor (MQ-3), allows you to measure the concentration of ethanol in the air. The module has an analogue output and an output triggered by exceeding the threshold of sensitivity.

Designed to pair with the MyoWare Muscle Sensor; 10-segment bar graph shows the magnitude of the measured signal. The more muscle activation measured, the higher up the board the lit LEDs will go. DEV-13688

The MQ-3 sensor allows you to measure the concentration of alcohol vapors. The measuring range of the sensor is in the range of 0.05 mg / L to 10mg / L, and an analogue signal is obtained at the output.

The soil moisture sensor with comparator LM393 has an analogue and digital output (with adjustable switching threshold). modHUM

Module with a UV light sensor LTR390-UV. It allows you to measure the intensity of ultraviolet radiation and visible light. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 4831

Module with DHT11 temperature and humidity sensor designed for Wemos D1 Mini

Digital temperature and humidity sensor with calibrated digital output signal. Equipped with a 2.5 mm 4-pin male stereo audio connector that works perfectly with the Sonoff TH10/TH16 socket. Sonoff Si7021

Module with an analog MQ2 gas sensor. It enables the detection of LPG, butane, propane, methane, alcohol, hydrogen and smoke. It is powered with the voltage of 5 V and has an analog output

Reflective sensor with digital output, enabling obstacle detection, with adjustable trigger threshold using a built-in potentiometer. The module can be connected directly to a microcontroller and development kits such as Arduino, Raspberry Pi, STM32 or ESP32

Waveshare Photo Interrupter Sensor is an IR optical sensor module with Schmitt trigger and a signaling diode allowing the construction of an incremental encoder. Waveshare Photo Interrupter Sensor

Module with an analog AC current sensor in a set with a probe for non-contact measurement of alternating current with a current of up to 10 A. DFRobot SEN0288

Module designed for the XIAO development platform. It acts as an advanced human presence sensor, using FMCW technology to detect human targets in a specific space. The module offers a maximum detection distance of up to 5 meters and a wide detection angle of ±60°. Seeed Studio 101010001