Category: Main categories

10-pin WF10S plug straight 2.54 thick, tin-plated. Set of 10 pieces

StarSBC series minicomputer with NXP i.MX6 ULL Y2 792MHz processor (Cortex-A7 core), 512 MB RAM, 4 GB eMMC memory, built-in Ethernet wired connectivity module. SoMLabs SLC2X6Y2_792C_512R_04GE_2ET_I

Protective cover for three batteries for DJI Mini 2 drones. Used to safely charge, store and transport Li-Po batteries

Protective cover for Li-Po batteries. Used to safely charge, store and transport cells

Magnetic pad dedicated to 3D printing. It has dimensions of 220x220 mm and is covered with a PEI coating on both sides

Magnetic pad dedicated to 3D printing. It has dimensions of 235x235 mm and is covered with a PEI coating on both sides

PCB board for parallel connection of packages with the XT30 connector. Used as an adapter for a battery charger

Adapter QFN20 to DIP20 in the form of a PCB. It can be used as an adapter for a programmer, breadboards or prototype structures

A module with an electret microphone and an amplifier that will allow you to detect a voice, a clap or a door slam using the analog output

Module with electromechanical relay. It allows you to control devices with an operating voltage of up to 250 V AC and a current of up to 3 A or a voltage of 30 V DC and a current of 3 A

Module with a magnetic sensor based on a reed switch. Reacts to the action of an electromagnet or a permanent magnet

The module with a black and white OLED display, 0.96" diagonal and 128x64 pixels resolution. Equipped with an XH2.54 connector, communicates via the I2C interface

A 12V DC linear actuator designed for precision automation, robotics, DIY projects, and light industrial applications. It offers a nominal stroke of 20 cm and a dynamic load capacity of up to 15 kgf, while maintaining static stability even without power. Built-in limit switches and a feedback potentiometer allow for safe and accurate piston position control, while the IP65-rated aluminum housing provides resistance to dust and moisture. The actuator operates smoothly and quietly at speeds up to 43.9 mm/s without load, and direction changes are achieved by reverse voltage polarity. Pololu 2323

HAT PoE overlay for Raspberry Pi. Allows you to use the Power over Ethernet interface to power a minicomputer via an RJ45 connector. Waveshare PoE HAT (E)

HAT module designed for Raspberry Pi minicomputer. Powala adds two RS485 interfaces and one CAN bus to the project. Waveshare RS485 CAN HAT (B)

Module with a color IPS LCD display with a diagonal of 1.54". It has a resolution of 240x240 pixels and an ST7789 controller. Communication with the module is realized via the SPI interface. Waveshare 1.54inch LCD Module

Goldpin black 2x4 pins connector. Simple to through-hole assembly. 1.27 mm pitch. PBHD08S. Zestaw zawiera 10 sztuk złącz