This heatsink might be useful for who needs a low noise solution with ODROID-XU4. The stock active cooler mounted on the XU4 is more efficient at dissipating heat away from the processor for most of use cases. But if you need a fan-less quiet system, this tall heatsink could be a solution. You can replace the active cooling fan with this passive heatsink. Down the max CPU clock of the XU4 to 1.4GHz if your system gets thermal throttling often.
This heat sink comes with the thermal paste tube. The thermal paste is responsible for conducting heat from the processor to the heat sink. Reassembling without applying thermal paste will cause the processor to overheat.
NOTE: If you clean the surface with alcohol or make any deep scratch on the surface, it can remove the anodizing coating. In that case, it can cause the short circuits condition and XU4 can be damaged. Be careful to minimize the stress on the surface of the heat sink.
Odroid XU4 NOT included.
Manufacturer BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Responsible person BTC Korporacja sp. z o. o. Lwowska 5 05-120 Legionowo Poland sprzedaz@kamami.pl 22 767 36 20
Module with OV5647 sensor cooperating with ODROID-M1. It uses a built-in movable IR-CUT filter that is turned on and off automatically depending on the lighting conditions. Odroid M1 MIPI-CSI Camera Kit
Module for an easier and faster way to write an operating system image to an eMMC module. Odroid USB3.0 eMMC Module Writer 2
No product available!
A set of all sockets and connectors not pre-installed in the Odroid-C0 computer
A set of four M12 lenses is an ideal choice to be used with oCam series cameras. Lens set without IR cut filter
7" TFT LCD display with touch screen for Odroid C1+, C2, N2 and XU4 computers. The display is equipped with HDMI interface for image display and USB for touch screen. Resolution 1024x600 pixels. ODROID-VU7A Plus
No product available!
No product available!
Pin strip straight in black, double-row, female with 2x20 layout, 2.54mm pitch and elongated legs (12mm). Thru-hole assembly (THT), often used to build GPIO modules for single board computers. PBD40S L
Micro USB-DC Power Bridge Board for ODROID-XU4 users who use ODROID-VU7 or VU7plus. This bridge board is to supply separated 5V power to the ODROID-VU7 and VU7 Plus
Kit for mounting the HDD in the Odroid M1 minicomputer. Hardkernel M1 SATA mount and cable kit
USB IO board for Odroid computers, compatible with XU4, C1 +, C1, C0, C2 versions
8" TFT LCD display with a touch panel dedicated to Odroid-M1 minicomputers. Equipped with MIPI-DSI interface. It has a resolution of 1280x800 pixels. ODROID-Vu8M
12 pin GPIO ribbon cable (200mm) for Odroid XU4 and Odroid XU4Q
No product available!
A new game controller that is similar to the steering wheel available for the Nintendo Wii. It is built using the USB IO BOARD and an auxiliary motion sensor, and allows you to play many games available for mobile phone that would normally use the phone’s gyroscope
IR Remote Controller - Works with the ODROID C1, C0, C2, N2, N2+, C4, HC4 on-board IR receiver
7 pin GPIO ribbon cable (20 cm) for Odroid C4
No product available!
40x40x25mm, for Odroid XU4