Best sellers

RS2204 2300 kV brushless motor with CCW

MT2204 2300kV brushless motor with CW

Brushless motor MN1806 2280 kV. Dedicated to drones

ESC RC controller module with FlySky receiver designed for two brush motors with a supply voltage from 2.5 to 5 V and a current consumption of 2 A

Module with SHT30 temperature and humidity sensor designed for Wemos D1 Mini

The module with an 8x8 LED matrix designed for Wemos D1 Mini

UPS uninterruptible power supply module for Raspberry Pi, allowing the microcomputer to continue working and shut down safely after a power failure. Uninterruptible power supply included. SB Components UPS HAT

Single-core, multi-strand wire in green silicone insulation. Thickness 22AWG, length 4m

Single-core, multi-strand wire in black silicone insulation. Thickness 26AWG, length 4m

Connector for connecting a 50-pin ribbon with a 0.5 mm pitch to a printed circuit board. Riverdi ZIF0550UH

Board with the GNSS Cinterion TX62 module with support for Cat. M1 and NB IoT. Dedicated for Arduino Portenta H7. Arduino ASX00027

Driver for e-Paper displays in the form of an overlay for Arduino and Nucleo. The SPI interface is used for communication with the controller. Waveshare e-Paper Shield

8 MPx camera module with IMX219 sensor and wide-angle lens. To be used as a replacement on the RPI Camera Board V2. Waveshare IMX219-D160

Camera module with OV5640 sensor with a resolution of 5 MP. Equipped with fisheye lens, it communicates via the SCCB interface. Waveshare OV5640 Camera Board (B)

Camera module with USB interface. Equipped with a CMOS IMX179 sensor with a resolution of 8 MP and a lens with a viewing angle of 145°, it has a built-in microphone. Waveshare IMX179 8MP USB Camera (A)

INEMO system: 3D accelerometer and 3D gyroscope in LGA16L housing, made by STMicroelectronics. Allows measurement of acceleration up to 16g and angular velocity up to 2000 degrees / second, communication takes place on the I2C / SPI bus

A female-female cable, 50 mm long, terminated on both sides with a JST-ZH 2-pin plug. Suitable for micro DC motor modules. Pimoroni CAB1012

Charger module with protection dedicated to LiPo and LiIon batteries. Equipped with a JST-PH battery connector and a USB Type-C charging connector. Pimoroni PIM612

Charger module dedicated to single-purpose LiPo and LiIon batteries. Equipped with a JST-PH battery connector and a USB Type-C charging connector. Pimoroni PIM611

The Microchip system in the DIP8 housing, a dual driver, allows the MOSFET transistors to be controlled with a high switching speed. The controller is characterized by low power consumption, high current efficiency when loading eg gate capacity, or ESD resistance up to 4kV