Best sellers

Li-Po battery with a rated voltage of 3.7 V and a capacity of 450 mAh, equipped with a PCM protection and a 2.5 JST-RCY connector. Akyga LP502248

Small metal gear motor, 30 RPM speed, 6V operating voltage. GA12-N20-0011

Universal multimeter that allows to measure DC and AC voltage, DC current, frequency and resistance. Equipped with diode tester, circuit continuity test, among other features. ANENG DM850

Module with the SX1276 868 MHz system for LoRa communication, designed for FireBeetle boards. It communicates via the SPI interface. DFRobot TEL0125

HDMI cable Akyga ver. 1.4 with a length of 5 m

El-wire is a thin and flexible wire which shines under high voltage. The cable is red, has a diameter of 3mm and a length of 50 meters

Inverter powered by 100 - 240 V AC, generates alternating current to power electroluminescent wires glowing under the influence of high voltage

LoRa wireless communication module dedicated to long-distance data transfer. It operates in the 433 MHz frequency band and is equipped with RS232, RS485 and RS422 industrial interfaces. With RS232 cable and power supply. Waveshare SX1262-LoRa-DTU-LF-Kit (EU)

Digital oscilloscope equipped with a 7" TFT LCD display. It has two measurement channels with a 200 MHz bandwidth, a sampling rate of 1 GSa/s and a 14 Mpkt memory buffer. Siglent SDS1202X-E

Module with the PIR EKMB1107112 motion sensor, the standby power consumption of up to 1 uA. SparkFun SEN-17373

Module with PIR EKMC4607112K motion sensor, power consumption in standby mode up to 170 uA. SparkFun SEN-17372

A module dedicated to Raspberry Pi power management. It has a built-in RP2040 microcontroller that controls the operation of the device. Waveshare Power Management HAT (B) (EU)

The UART-USB converter built on the FTDI FT232RL chip. Compatible with 3.3V and 5V voltages. DFRobot DFR0065

Cap for Xbee and Arduino. It has been designed for wireless sensor networks such as WiFi, Bluetooth 2.0 / 4.0 and Zigbee. DFRobot DFR0015

Flexible Qwiic cable, 150 mm long. On one side it is terminated with a female Qwiic connector, and on the other side with single female goldpin connectors. SparkFun PRT-17261

Two-channel motor controller with L298N system with 4.8 ... 46V motor power supply and 2A current capacity per channel. It has a protection in the form of diodes. DFRobot DRI0002

Set of 10 cables, 50 cm long, for digital sensors compliant with the Gravity standard. DFRobot FIT0756

The IO expansion module is designed to work with the micro: bit educational board. There are 19 IO pins on the board, a buzzer and a voltage stabilization circuit are placed. DFRobot MBT0008

Small size driver module TB67S279FTG stepper motor powered with 10 ... 47V voltage and working current 1.1A. The controller allows you to control the motor movement up to 7 different resolutions (up to 1/32 of a step). Polol 3098

A set of test leads 2x4 (4 signal and 4 GND) with a length of 23cm and 22AWG intended for logic analyzers Saleae.