Best sellers
There are 16475 products.
The Digilent Cmod A7 is a small, breadboard friendly 48-pin DIP form factor board built around a Xilinx Artix-7 FPGA. The board also includes a USB-JTAG programming circuit, USB-UART bridge, clock source, Pmod host connector, SRAM, Quad-SPI Flash, and basic I/O devices. 410-328
Camera for Raspberry Pi Compute Module and NVIDIA Jetson Nano. It was equipped with a Sony IMX477 sensor with a resolution of 12.3 MPx and a built-in IR filter. Waveshare IMX477-160 12.3MP Camera
Miniature high-power motor from the Pololu MP series. 100: 1 gear motor,
the rotation speed of the shaft is 220 rpm, the torque is 1.5 kg * cm (0.15 Nm).
The motor has an extended shaft which makes it easy to attach the encoder. Pololu 2381
A set of converters (transmitter and receiver) HDMI-RJ45 allowing the transmission of HDMI signal up to a distance of 60 m
360-degree laser scanner (LIDAR) with a range of up to 10 meters and a measurement frequency of up to 12 Hz. LIDAR X4
Electronic worm in the form of a kit for self-assembly. It is powered by a DC motor and powered by a set of two AA batteries
ToF distance sensor (Time of flight) with a range of up to 60 cm. The module is powered with the voltage of 3.3 V and communicates via the I2C interface. DFRobot SEN0429
Development board with ATmega328P microcontroller compatible with Arduino Uno Rev3. Waveshare R3 PLUS
Metal stand for Elwik LES-1 soldering irons with a tip cleaning sponge.
Module with analogue UV light sensor ML8511. It enables the measurement of the radiation intensity for the UV-A (320-400nm) and UV-B (280-320nm) waves. It has an analog interface. GY8511
Housing for Raspberry Pi 3/2 / B + two-colored (black-transparent). Mounted on screws without the use of glue, made of plastic
Camera with a resolution of 5 MPx with a USB interface. Equipped with a CMOS OV5648 sensor and a microphone. ArduCAM UB0238
Tip GD-2 No. 050 mounted on the heater. Suitable for all types of Elwik soldering irons.
The module is equipped with two buttons in red and blue. It communicates via a digital interface and allows you to add simple controls to your M5Stack based project. M5Stack U025
24-channel portable logic analyzer with 16-channel digital waveform generator. Digilent 410-338
Waterproof temperature sensor adapted to work with Sonoff TH10 / TH16
A universal multimeter allows you to measure direct and alternating voltage, direct and alternating current, resistance, temperature and capacity as well as frequency. Equipped with diode tester, continuity test, Hold function, automatic switch off and automatic backlight. Uni-T UT890C
Tip GD-1 No. 046 mounted on the heater. Suitable for all types of Elwik soldering irons.
NFC reader with USB interface. It allows you to easily read data from an NFC/RFID card using a computer