Best sellers
There are 16495 products.
LCD graphic display with 128 x 64 resolution, black content, white backlight, based on RA8808 controller.
Red laser diode module with 5mW power, displaying the line. Ideally suited to the determination of straight lines, and thanks to the built-in driver, it is possible to supply voltage of 3 ... 5V. LD-G650A03 - Line
RS-232 D-Sub (f) / D-Sub (m) cable, 2 m long. Akyga AK-CO-01
2x16 display with LED backlight (AMBER) FSTN, 80x36 mm, extended temperature range "fast" 2LED backlight, (second character set - CYRIL) v.E31-FIA
N-channel 120V 7.9mΩ standard level MOSFET in TO220, TO-220AB, NXP, RoHS
This RGB LED HAT can be easily attached on top of the Raspberry Pi to display colorful effect, and controlled by only one signal pin.
Insulated flat screwdriver YT-28174
A pair of aluminum brackets with holes for M3 screws for 37D mm gear motors. Pololu 1084
LED backlight. Yellow. light 2.7 lm 12V 20mA 595nm, waterproof housing, easy self-adhesive assembly
Side cutter YT-21158 with VDE insulation, made of high quality CrV steel.
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output in the form of pads. Allows powering devices with 12V. PDC004
Module with BME680 sensor for measuring environmental conditions such as concentration of volatile organic compounds (VOC), atmospheric pressure, temperature and humidity. I2C or SPI communication. SparkFun SEN-16466
Adafruit 603 - Stainless Thin Conductive Yarn / Thick Conductive Thread - 35 ft
The trigger module is designed for chargers PD 2.0 and PD 3.0. It is equipped with a USB type C input and an output on a 5.08 mm ARK screw connector. Allows you to power devices with 5 V, 9 V, 12 V, 15 V and 20 V and test chargers by replacing the PD device
The X-NUCLEO-IHM03A1 plate allows the control of a high-power stepper motor; the maximum current of the phase is 10A rms, additionally the controller enables execution up to 1/128 step and has a number of protections. X-NUCLEO-IHM03A1
Module with MEMS microphone; model SPW2430 with built-in amplifier. The plate also has a 3.3 V voltage stabilizer needed to power the microphone. Adafruit 2716
Range finder with a measuring range up to 12m. The current consumption is up to 120mA and the supply voltage 4.5 ... 6V. Communication via the UART interface. DFRobot SEN0259
