Best sellers
There are 15480 products.
8 Mpx camera module with IMX219 sensor with low distortion lens. The camera is intended for use as a replacement on the RPI Camera Board V2. ArduCAM B0184
Cleanser IPA PLUS 150ml spray with a brush is a product based on isopropyl alcohol for cleaning optics and electronics. MICRO CHIP ELEKTRONIC ART.108
3.5" LCD IPS display with touch screen. The display is equipped with an SPI interface for image display and touch screen operation. Resolution 480x320 pixels. Waveshare 3.5inch RPi LCD (B)
Raspberry Pi Camera Module, Fixed-focus, 5 megapixel OV5647 sensor in a fixed-focus module. Waveshare RPi Camera (D)
The board is equipped with ATSAME51 microcontroller (ARM Cortex-M core) with CAN bus and SPI Flash memory, GPIO pins and a connector for connecting the battery with the charging circuit. Adafruit 4759
Module with e-Paper display, 3.7" diagonal and 480x280 px resolution. Communication via SPI interface. Waveshare 3.7inch e-Paper HAT
A specialized liquid intended for cleaning cartridges and nozzles of all types of inkjet printers. MICRO CHIP ELECTRONIC ART.150
Industrial input/output expansion board based on VNI8200XP and CLT01-38SQ7 for STM32 Nucleo
Tip GD-1 No. 048 mounted on the heater. Suitable for all types of Elwik soldering irons.
I2C bus amplifier module based on the LTC4311 system. It enables communication via a popular interface over much longer distances while maintaining high transmission speeds. Adafruit 4756
Rotating signal lamp powered with 12 V DC, yellow. LTE-1101
Module with a digital temperature sensor PCT2075. It enables measurement in the range from -25 to 100°C with an accuracy of ±1°C. Communicates via I2C. Adafruit 4369
This small synchronous switching step-down (or buck) regulator takes an input voltage from 4 V to 36 V and efficiently reduces it to 3.3 V. The board measures only 0.7″ × 0.7″ yet delivers a typical continuous output current of up to 2.6 A and features reverse voltage protection.
BNC connector cable (adapter) to the "Alligator clip" connector. It allows you to conveniently connect the device, e.g. to an oscilloscope. Digilent (240-134)
Module with acceleration and rotational speed sensor based on the LSM6DSOX system. Equipped with a STEMMA QT connector, it communicates via the I2C or SPI interface. Adafruit 4438
Multi-functional USB tester. It allows you to check the voltage and current flowing through the USB socket and to control the capacity, energy, temperature and impedance. UM25
Module with a GPS receiver based on the MTK3333 chip. It is equipped with a STEMMA QT connector and communicates via the UART or I2C interface. Adafruit 4415
Tip GD-2 No. 049 mounted on the heater. Suitable for all types of Elwik soldering irons.
Micro analog servo with plastic gear. It has a range of motion of 180°. Pololu 1049