Best sellers
There are 16475 products.
32-bit STM32L1 microcontroller with ARM Cortex-M3 core, 128kB Flash memory, 32kB RAM memory, 32MHz, 48-LQFP housing
Triak in a TO-220 housing from STM with a maximum voltage of 600V and 6A RMS current. It has a gate current up to 50mA
Varta Superlife AA (R6) zinc-carbon batteries with a voltage of 1.5V are designed for low-power devices such as wall clocks and remote controls. Packed in sets of 4 in foil, they provide a cost-effective solution for basic energy needs.
Two-channel DC motor driver with an operating voltage from 7 to 35 V and a maximum continuous current of 30 A. It can be controlled by an analog signal, PWM, UART, RC signal or by means of built-in buttons. Cytron MDDS30
The TQSolution FE80FI45 filter, measuring 80x80x2.5 mm, is designed to protect the LFT80FI45 fan
The 2-way waterproof twisted connector with a screw terminal is a universal, easy-to-install and weather-resistant element connecting two wires, ideal for difficult tasks such as garden lighting installation or outdoor electrical work
Pulley GT2 30T B5 for a shaft with a diameter of 5 mm. It has 30 teeth, suitable for a 6mm wide belt
A servo tester that allows the testing and diagnosis of model servos. It has 8 output channels. It can be controlled by pushbuttons, knob or external PWM, PPM and SBUS signals. ToolkitRC ST8
Development kit with ESP32 WiFi and Bluetooth module and 0.96 "OLED display. It has a built-in Li-Pol charger module and a USB-UART converter function. ModOLEDESP32_V2.0_TTGO
The official camera module designed to work with Raspberry Pi minicomputers. Equipped with a Sony IMX708 sensor with a resolution of 12 Mpx and a lens with a viewing angle of 75 ° with autofocus. Version without IR filter. Raspberry Pi SC0875
Panel button, bistable, rectangular, dimensions 16 x 22 mm and SPDT contact configuration
Holder for attaching the glass to the 3D printer table in the form of a clamp clip
STM32WB55CGU6, ARM Cortex-M4 MCU 64 MHz, Cortex-M0+ 32MHz with 1 Mbyte Flash, Bluetooth 5, 802.15.4, UFQFPN-48
The High Speed Logic Probes is a set consisting of 4 double wires (twisted), with the help of which it is possible to obtain a measurement with a sampling frequency of up to 800 MS / s using the Digital Discovery analyzer. Each signal cable has a built-in 100 ohm resistor located closest to the tested system. Digilent 240-116
Converter that provides easy communication between the RS232 and RJ45 Ethernet interface. Configurable via web page or AT commands. USR-DR301
15.6" LCD display with touch screen. The display is equipped with HDMI interface for image display and USB for touch screen. High resolution 1920x1080 pixels. Waveshare 15.6inch HDMI LCD (for EU)
A chemically pure, non-toxic cooling preparation for troubleshooting using the thermal method, it quickly cools down to -55 ° C. MICRO CHIP ELEKTRONIC ART. 123
Easy-to-install indicator signaling the operation of devices or systems, with an attached resistor and adapted to work with 12V supply voltage
10.1" LCD IPS display with touch screen. The display is equipped with HDMI interface for image display and USB for touch screen. High resolution 1024x600 pixels. Waveshare 10.1inch HDMI LCD (E)
Easy-to-install indicator signaling the operation of devices or systems, with an attached resistor and adapted to work with 12V supply voltage