Best sellers
There are 16522 products.
Practical solution for converting DC connectors in electronics projects, enabling safe and stable power connections. ADP0023
Female terminal block, 3-pin. Pitch 3.5mm. Height 7.8mm. Suitable for KF2EDGR male strips with a pitch of 3.5 mm. 2EDGKN-3.5
The KAmod ESP32-C3 board, equipped with a RISC-V microcontroller and a set of MEMS and SHTC3 sensors, enables the creation of IoT, measurement, and control applications. Thanks to power from USB-C or a battery and support for Arduino and Rust, it works perfectly in mobile projects and embedded systems.
IC socket in DIP24W package, 24-pin, 2.54 mm pitch, 15.24 mm pitch, RoHS
The NRF24L01+ chip module for radio communication, which operates in the 2.4 GHz ISM band. It is used in various applications such as wireless sensors, remote control, wireless networks. It supports the Enhanced ShockBurst protocol, which provides automatic packet handling. It communicates via an SPI interface
Neodymium rectangular magnet with dimensions of 30x10mm a and a height of 3 mm.
The MQ-5 sensor allows the measurement of alcohol and gas concentrations, such as methane, LPG, and carbon monoxide. Sensor measuring range: up to 10,000 ppm
Waterproof connector with plug, gaskets and contacts included. It can work with a voltage of up to 300 V and a current of up to 12 A
Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.
6-wire cable, 30 cm long, with a JST PH-2.0 female plug at one end
12-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end
JST SH type connector, 1.0 mm pitch, surface mounted, vertical spatial orientation. The set includes 10 connectors
HC-08 is a module operating in the Bluetooth Low Energy 4.0 standard. The system has a built-in antenna and small dimensions, and thanks to edge joints it can be surface soldered. The module is configured via AT commands
A module with a 3-axis accelerometer that allows you to measure acceleration in the range of ± 16g with a resolution of 13 bits. GY-291 ADXL345
Electronic components tester with a 128x64 pixel display. It allows you to check, among others transistors, diodes, capacitors, resistors and inductors. Acrylic housing included. LCR-T4
Soldering paste medium-active flux with the consistency of a paste based on rosin and organic halogen activator, facilitating the soldering of copper, silver, zinc and nickel elements. AG Termopasty ART.AGT-037
YATO YT-81500 19mm cable harness tape. The tape is intended for organizing and securing electric cable bundles.
The KAmod BlackPill 411 is an evaluation board featuring the STM32F411CEU microcontroller, offering versatile programming capabilities with a USB-C connector and a pre-installed bootloader compatible with Arduino IDE. Equipped with 32 GPIOs, a modified power circuit, and ESD protection, it is perfect for embedded projects.
