Best sellers

Logic Analyzer USB

Basys3 is an entry-level FPGA board designed exclusively for the Vivado Design Suite, featuring Xilinx Artix 7-FPGA architecture. 410-183

The USB Step-Up converter module converts 3.5-12V input voltage to 4-24V output, offering different power values depending on the voltage level. Equipped with a 3-bit digital display, it has a compact size of 80 x 20 x 14mm.

Vector network analyzer with two ports. It can perform measurements for frequencies from 50 kHz to 4.4 GHz. Equipped with an LCD display, it can be connected to a computer via USB. Nanovna V2 4"

Thermal imaging camera module with an MLX90640 infrared sensor and a 2.8" TFT LCD display. It offers an accuracy of 2°C and a viewing angle of 55°x35°.

COB LED ring, made of aluminum PCB, emits cold white light (6000-6500k) at 12 V DC with a maximum current consumption of 350 mA, offering a wide beam angle of 120 °

Li-Fe battery monitor that can measure voltage, current, power during charging and discharging, and watt-hours consumed and run time. The user can use a mobile application and a computer to control the measuring module. Juntek KG110F

The module with 6 capacitive touch buttons and LED diodes, designed to work with the Raspberry Pi. The buttons are connected to the minicomputer via the CAP1166 controller, which communicates via the I2C interface. Pimoroni PIM272

Module with air quality sensor SGP30. It allows you to read the concentration of VOC (TVOC) and eCO2 and communicates via the I2C interface. Pimoroni PIM480

8-bit ST7 MCU, 8kB Flash, 256B RAM, Watchdog timer, Two 16-bit timers, SPI, I2C, ADC, DIP32

A small module with a 3-axis magnetometer based on the Melexis MLX90393 system. Its resolution is 0.161 μT. I2C or SPI interface is used for communication. The I2C interface has been derived on connectors compatible with the Qwiic standard. SparkFun SEN-14571

COB LED ring, made of aluminum PCB, emits cold white light (6000-6500k) at 12 V DC with a maximum current consumption of 800 mA, offering a wide beam angle of 120 °

Module with a 0.96" IPS color LCD display and a resolution of 160x80 pixels. It uses the ST7735S controller and communicates via the SPI interface. Pimoroni PIM436

Module with 5x5 RGB LED matrix display (25 LEDs). It uses the IS31FL3731 driver and communicates via the I2C interface. Pimoroni PIM435

The module with a black and white OLED display with a diagonal of 1.12" and a resolution of 128x128 pixels. It uses the SH1107 controller and communicates via the SPI interface. Pimoroni PIM473

Adafruit 364

Module with IO expander equipped with 14 inputs/outputs, including 8 connected to the ADC converter and 6 to PWM outputs. It communicates via the I2C interface and is compatible with the Raspberry Pi. Pimoroni PIM517

LoRa radio module with 433 MHz operating frequency. Communication takes place via the UART serial interface. It is supplied with the voltage in the range from 3.4 to 5.5 V. DFRobot TEL0116

COB LED ring, made of aluminum PCB, emits warm white light (2800-3000k) at 12 V DC with a maximum current consumption of 300 mA, offering a wide beam angle of 120 °

Set of "sleeping lion" with the educational module micro: bit. It consists of a main plate, noise: bit and felt elements, thread and needle to create the toy. Pimoroni PIM363