Best sellers
There are 16603 products.
Multifunctional robot with 2WD chassis and controller in the form of a Raspberry Pi minicomputer. It is a universal mobile platform that can, for example, follow a line or search for and avoid obstacles. Waveshare AlphaBot2-Pi Acce Pack
FeatherWing Doubler is a shield that allows you to create your own layout based on two or one Feather series. The plate has 256 holes, including designated, common solder points for supply voltages. Adafruit 2890
At the Feather M0\'s heart is an ATSAMD21G18 ARM Cortex M0 processor, clocked at 48 MHz and at 3.3V logic. 256K FLASH, 32K RAM, built in USB and battery charging. Adafruit 2772
Module with a temperature and humidity sensor based on the SHT31-D system. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 2857
Module with ACS724LLCTR-05AB current sensor with a measuring range of direct and alternating current from -5 to 5 A. It communicates via an analog interface. Pololu 4041
At the Feather M0\'s heart is an ATSAMD21G18 ARM Cortex M0 processor, clocked at 48 MHz and at 3.3V logic, the same one used in the new Arduino Zero. This chip has a whopping 256K of FLASH (8x more than the Atmega328 or 32u4) and 32K of RAM (16x as much). Adafruit 2796
Module with ACS724LLCTR-10AU current sensor with a measuring range of direct and alternating current from 0 to 10 A. It communicates via an analog interface. Pololu 4042
Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16446
3mm white LED. 1000 pieces in the package
Low Energy Bluetooth adapter module with USB 2.0 connector. allows communication with BLE devices
3mm orange LED. 1000 pieces in the package
Expander (shield) compatible with Arduino and NUCLEO (STM32) systems, equipped with a Bluetooth 4.1 (BLE) radio module from the SPBTLE-RF family
RC extension cable dedicated to servos, comes with JR/Futaba female and male connectors. It has twisted wires
Programmable wireless BT4.0 transmitter, compatible with sensors of the iNode Care Sensor series. It allows you to enable / disable other devices, eg after exceeding the set temperature or humidity, moving the sensor or changing its position. Allows you to control directly from your smartphone, tablet or computer
Low Energy Bluetooth adapter module with 2x4 pin 2.54mm connector, extra / high. RS232 allows communication with BLE devices
Qwiic adapter designed for micro:bit educational modules. Facilitates access to all pins that are led out on the connector with a pitch of 2.54 mm and the Qwiic connector. SparkFun BOB-16445
Intelligent RFID identifier cooperating with iNode Control Point