STEMMA QT Sensirion SHT31-D - module with temperature and humidity sensor

Module with a temperature and humidity sensor based on the SHT31-D system. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 2857

Adafruit module with Si7021 temperature and humidity sensor. Sensor Sillicon Labs can measure temperature in the range of -10 ~ 125 ° C, and humidity in the range of 0-100 & RH. The sensor communicates using the I2C interface. Adafruit 3251

The module has a humidity sensor (accuracy ± 2% RH) and temperature with an accuracy of ± 0.3 ° C. Communication takes place via the I2C bus

Module with humidity and air temperature sensor based on the AM2302 system. It allows temperature measurement in the range from -40 to 80 ° C and the humidity measurement takes place in the range of 5 to 99% RH. The module has a connector in accordance with the Grove standard. Seeed Studio 101020019

Temperature and humidity sensor adapted to work with Sonoff TH10 / TH16

BME280 integrates onboard temperature sensor, humidity sensor and barometer. It provides both SPI and I2C interfaces; and can be widely used in environmental monitoring, story height measurement and Internet of Things (IoT) control and so on. SEN0236

Temperature and humidity sensor SHT20 closed in a waterproof housing. Communication via the I2C interface. DFRobot SEN0227

Temperature and humidity sensor module with DHT22 sensor (AM2302)

I2C BME680 Environmental Sensor is a gas, pressure, temperature and humidity sensor in one MEMS housing. The module is supplied with 3.3-5V, for communication the I2C or SPI interface is used. DFRobot SEN0248

Module with temperature and humidity sensor DHT11. It allows you to measure humidity in the range of 20 ... 90% and temperature (0 ... 50 ° C). DFRobot DFR0067

Digital temperature and humidity sensor with calibrated digital output signal. Equipped with a 2.5 mm 4-pin male stereo audio connector that works perfectly with the Sonoff TH10/TH16 socket. Sonoff Si7021

Analogue temperature and humidity sensor module based on SHT30 sensor. It is characterized by high reliability and stability with low energy consumption. It is compatible with 3.3V and 5V controllers, such as Arduino, micro:bit, ESP32. DFRobot DFR0588

Module with temperature, humidity and pressure sensor BME680 from Bosch. The module communicates via I2C or SPI interfaces.

Air humidity and temperature sensor with 1-Wire interface.

Grove module with temperature, humidity and pressure sensor. The board is equipped with a Grove connector and communicates via I2C or SPI. Seeed Studio 101020193

Module with a digital temperature and humidity sensor based on the SHT31-F system. Communication via the I2C interface. Equipped with a Gravity DFRobot SEN0334 connector