Best sellers
There are 16467 products.
Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.
The KAmod ESP32-C3 board, equipped with a RISC-V microcontroller and a set of MEMS and SHTC3 sensors, enables the creation of IoT, measurement, and control applications. Thanks to power from USB-C or a battery and support for Arduino and Rust, it works perfectly in mobile projects and embedded systems.
The KAmod BlackPill 411 is an evaluation board featuring the STM32F411CEU microcontroller, offering versatile programming capabilities with a USB-C connector and a pre-installed bootloader compatible with Arduino IDE. Equipped with 32 GPIOs, a modified power circuit, and ESD protection, it is perfect for embedded projects.
12-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end
Needle bending needle, for precise glue application, Flux 1.60mm internal diameter and 2,108mm outside diameter. Set of 5 pcs
Unshielded UTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCU6-10CC-0100-R
Unshielded UTP category 6 Ethernet network cable with RJ45 plugs. Lanberg PCU6-10CC-0500-W
A 7-pin cable with a length of 30 cm, terminated on one side with a Molex Picoblade 1.25 mm plug
IC socket in DIP32N package, 32-pin, 2.54 mm pitch, 7.62 mm pitch, RoHS
4-wire cable, 10 cm long, with a micro 5264 female plug at one end
ARK terminal connector with a fuse, 4-pin, pitch 10.00 mm, non-detachable.
USB-UART TTL converter based on the CH343G chip. Equipped with a number of security features ensuring stable and safe communication. Waveshare CH343 USB UART Board (type A)
The RJ45 keystone connector is a universal solution for building networks in surface and flush versions, mounting in keystone boxes and 10" and 19" panels, as well as for connecting cables with RJ45 8p8c plugs
KEMOT insulation tape in gray, 0.13x19 mm, 9.14 meters long
THT resistor, 0.25W, 5%, RoHS
Development board D1 Mini V3 with WiFi module ESP-8266 and 4 MB Flash memory. The module can be programmed from the Arduino IDE level. WeMos D1 Mini V3.x
The LS Q976-NR-1 is a red SMD LED with a wavelength of 633 nm and a brightness of 180 mcd at 20 mA current. Thanks to its compact 0603 package (1.6 mm x 0.8 mm x 0.8 mm), it is ideal for space-saving applications such as display backlighting or signaling in electronic devices. The LED features a viewing angle of 160° and a typical forward voltage of 2 V, making it an efficient and versatile component for electronic projects.
Needle bending needle, for precise glue application, Flux 0,311mm internal diameter and 1.26mm outside diameter. Set of 5 pcs
Permanent cylindrical neodymium magnet with a diameter of 10 mm and a height of 1 mm. Set of 10 pcs
Insulating tape by REBEL, black, dimensions 0.13x19 mm and length 10 m