Best sellers
There are 16460 products.
Female terminal block, 3-pin. Pitch 3.5mm. Height 7.8mm. Suitable for KF2EDGR male strips with a pitch of 3.5 mm. 2EDGKN-3.5
Needle bending needle, for precise glue application, Flux 0.413mm internal diameter and 0,7176mm outside diameter. Set of 5 pcs
Lanberg Cat. 6A patch cord with Fluke Passed certification guarantees the highest quality and reliability, enabling optimal network connection compatible with various network devices in any environment. Lanberg PCF6A-10CC-0025-BK
IC socket in DIP24W package, 24-pin, 2.54 mm pitch, 15.24 mm pitch, RoHS
Permanent cylindrical neodymium magnet with a diameter of 6 mm and a height of 5 mm. Set of 10 pcs
ARK terminal connector spring 8-pin, pitch 3.81 mm, non-detachable
12-wire cable, 10 cm long, with a JST SH-1.0 female plug at one end
The NRF24L01+ chip module for radio communication, which operates in the 2.4 GHz ISM band. It is used in various applications such as wireless sensors, remote control, wireless networks. It supports the Enhanced ShockBurst protocol, which provides automatic packet handling. It communicates via an SPI interface
Momentary button with a diameter of 16 mm and a height of 25 mm. Blue colour
A set consisting of the most commonly used goldpin connectors
FPC/FFC 24-pin adapter with 0.5mm pitch for DIP holes 2.54mm pitch.
A set of three wire brushes that are perfect for removing rust, paint, plaster remnants and other difficult dirt from various hard surfaces. It includes brushes with bristles made of various materials, such as stainless steel, brass and nylon, so you can easily adapt the tool to a specific type of cleaning. Vorel 06963
Neodymium rectangular magnet with dimensions of 30x10mm a and a height of 3 mm.
Straight dowel strip with a pitch of 2.54 mm in a 1x3 arrangement. The set contains 10 pieces
The KAmod ESP32-C3 board, equipped with a RISC-V microcontroller and a set of MEMS and SHTC3 sensors, enables the creation of IoT, measurement, and control applications. Thanks to power from USB-C or a battery and support for Arduino and Rust, it works perfectly in mobile projects and embedded systems.
Compact stepper motor controller with the TMC2130 system with operating voltage from 5.5 to 45 V. It offers smooth, quiet operation, high efficiency, various operating modes and easy configuration. It is controlled via the STEP/DIR interface and is an ideal solution for 3D printers and similar applications. BIGTREETECH TMC2130 V3.0
6-wire cable, 30 cm long, with a JST PH-2.0 female plug at one end
Unshielded UTP category 5E Ethernet network cable with RJ45 plugs. Lanberg PCU5-10CC-0050-B
Development kit with STM32L496ZGT6 microcontroller with built-in ST-Link programmer. Extensive equipment, including: MEMS 6DoF sensor, motor controller, joystick, LED display, 8 LED diodes, RGB LED, audio amplifier, Flash memory QSPI 1 MB, microphone.