New products
New products New products
Best sellers
There are 16594 products.
C-mount mirrorless lens. Focal length 35 mm, FoV 18°. Designed to work with the Raspberry Pi HQ camera. ArduCAM LN052
Development board with Allwinner F1C200S processor. It is equipped with 64 MB DDR RAM and 128 MB Nand Flash. It was designed to run under Linux and Python programming. DFRobot DFR0780
CS-Mount lens. 8 mm focal length, 50° FoV, manual focus and adjustable aperture. Designed to work with the Raspberry Pi HQ camera. ArduCAM LN039
Wide angle lens with CS-Mount. Focal length 6 mm, FoV 65°, manual focus and adjustable aperture. Designed to work with the Raspberry Pi HQ camera. ArduCAM LN037
8-digit, 8-segment LED display module with 16-level brightness adjustment. Communication via the I2C interface. DFRobot DFR0646-R
USB cable with an advanced system for simulating penetration attacks. It allows for keyboard and mouse emulation. The perfect tool for both beginners and professionals. O.MG Cable Basic USB-A/USB-C (Black)
Color Sensor, complete color detector
USB adapter for PC, allowing Bluetooth v4.0 communication with speeds up to 3Mb / s and range up to 20m
Audio module with DAC, headphone amplifier and display, designed to work with the Raspberry Pi. It is based on the PCM5100A system and communicates via the I2S interface. Pimoroni PIM482
Two axis stepper motor driver expansion board based on the L6470 for STM32 Nucleo
Module with a UV light sensor LTR390-UV. It allows you to measure the intensity of ultraviolet radiation and visible light. It communicates via the I2C interface. Waveshare UV Sensor (C)
The Qwiic connector overlay provides an easy-to-install way to add Qwiic connectors to Arduino Nano inserts. Communication takes place via the I2C interface. Sparkfun DEV-16789
DC-DC LED driver expansion board based on LED6001 for STM32 Nucleo
Module with 16x10 RGB LED matrix display (160 diodes) designed to work with the Raspberry Pi Pico. Communicates via a digital interface. Waveshare Pico-RGB-LED
The Qwiic connector overlay provides an easy-to-install way to add Qwiic connectors to Thing Plus and Feather boards. Communication takes place via the I2C interface. Sparkfun DEV-16790
STM32 Nucleo-144 development board with STM32F207ZG MCU, supports Arduino, ST Zio and morpho connectivity
Expansion board with Bluetooth v5.0 compatible module. The set is based on the BlueNRG-M2SP certified module with the BlueNRG-2 SOC system. The producer provides together with the module a library of Bluetooth LE protocol stacks. STMicroelectronics X-NUCLEO-BNRG2A1