Best sellers
There are 17618 products.
Adafruit Feather HUZZAH ESP8266 is a new development board from Adafruit with a built-in WiFi module ESP8266. Processor frequency: 80 MHz, USB-serial TTL CP2104 converter, Li-Pol battery charger. Adafruit 2821
STM32 Nucleo-144 development board with STM32F303ZE MCU, supports Arduino, ST Zio and morpho connectivity
Module with digital light intensity sensor MAX44009. It is supplied with the voltage from 1.7 to 3.6 V and communicates via the I2C interface. GY-49
Module with a 3-axis LIS3DSH accelerometer. The board is equipped with a goldpin connector and communicates via the I2C or SPI interface
5V relay module with IR receiver. Comes with a remote control
STM32 Nucleo-144 development board with STM32F207ZG MCU, supports Arduino, ST Zio and morpho connectivity
Module with 6-digit 7-segment LED display. The board is equipped with a TM1637 driver and communicates via a digital interface
Module with 6-digit 7-segment LED display. The board is equipped with a TM1637 driver and communicates via a digital interface
A set of conductive materials dedicated to device prototyping. DFRobot FIT0823
DC Micro motor module with metal gear with a gear ratio of 30:1. The motor is connected to the board containing the driver. DFRobot DFR0399
RC splitter cable dedicated to the servos, comes with a male and two female JR / Futaba connectors. Length 25 cm, diameter 26 AWG, twisted
Ethernet network module with W5500 chip and PoE (Power over Ethernet) function. It communicates via the SPI interface, it has a built-in TCP/IP stack. DFRobot DFR0850
Touch keyboard module with 4 buttons based on the TTP224 system. It is equipped with a connector with derived signals and 4 LEDs signaling the state of each button
Module with ToF distance sensor based on the VL53L0X system. It offers a range from 3 to 200 cm and communicates via the I2C, UART or Modbus interface. TOF200F
Intelligent relay cooperating with iNode Control ID
Intelligent RFID identifier cooperating with iNode Control Point
Low Energy Bluetooth adapter module with 2x4 pin 2.54mm connector, extra / high. RS232 allows communication with BLE devices
Low Energy Bluetooth adapter module with USB 2.0 connector. allows communication with BLE devices
Programmable wireless BT4.0 transmitter, compatible with sensors of the iNode Care Sensor series. It allows you to enable / disable other devices, eg after exceeding the set temperature or humidity, moving the sensor or changing its position. Allows you to control directly from your smartphone, tablet or computer