Best sellers
There are 17615 products.
J-Link BASE is a USB powered debug probe supporting a large number of CPU cores. Based on a 32-bit RISC CPU, it can communicate at high speed with the supported target CPUs. J-link BASE Compact (8.19.00)
Adafruit HUZZAH32 is a development board with a built-in WiFi ESP32 module. Processor frequency: 240 MHz, Li-Pol battery charging system. Adafruit 3405
Extension module with terminal blocks compatible with Arduino Uno connectors. DFRobot DFR0224
Evaluation board with ATSAMD21 microcontroller with ARM Cortex M0 core. Equipped with motion, temperature, light, sound sensors and RGB diodes. Can be programmed in MakeCode, CircuitPython, Arduino IDE or CS Discoveries. Adafruit 3333
With the help of a thermocouple, it is possible to measure the temperature of the air and the surface. The use of a steel stainless steel tip in a K-type thermocouple allows the temperature to be measured up to 500 ° C. The cord length is approximately 100 centimeters. Adafruit 3245
Nano I / O Shield for Arduino Nano is an expansion board for Arduino Nano that provides digital, analog pins, power inputs and a connector for the Bluetooth module. DFRobot DFR0012
UV Sensor with response spectrum: 200nm-370nm
Arty S7-50 is a development kit with Xilinix FPGA XC7S50-CSGA324. The board has many peripherals: slide switches, monostable buttons, RGB LEDs etc. Digilent (410-352)
The Tic T825 USB Multi-Interface Stepper Motor Controller makes basic control of a stepper motor easy, with quick configuration over USB using our free software. The controller supports six control interfaces: USB, TTL serial, I²C, analog voltage (potentiometer), quadrature encoder, and hobby radio control (RC).
An IoT module that combines a microcontroller with an ARM-Cortex M3 core, WiFi and NFC. It can be programmed in the Arduino IDE or in the Micropython language. DFRobot DFR0477
The FT90R is a digital micro servo that has been built by FEETECH specifically for continuous rotation, offering an inexpensive and easy way to get your small turret spinning or miniature robot moving, especially when paired with 60×8mm wheels designed specifically for this servo.
Water Turbine Generator is a water turbine that generates electricity. 5V output voltage on the turbine is achieved at a flow of 4l / min. DFRobot SEN0229
Adapter from HDMI to VGA with microUSB power input and 3.5mm audio jack, 15cm
The board is equipped with ATSAMD51 microcontroller with ARM Cortex-M4 core and SPI Flash memory, communication interfaces and RGB diode. Adafruit 3382
Vibration motor driver with support for various vibration effects. For communication, it uses the I2C interface led out to the Stemma QT and goldpin connectors. It is compatible with LRA and ERM engines. Adafruit 2305
Soldering rosin with the addition of activators, thanks to which it has an activity similar to solder paste. 500 g package. AG Termopasty ART.AGT-268
5" AMOLED display with touch screen. Equipped with HDMI interface for image display and USB for touch screen. Resolution 960x544 pixels. Waveshare 5inch HDMI AMOLED
Development board with Bluetooth 5.2 BGM220P module from Silicon Labs. It is equipped with a mikroBUS socket and a Qwiic connector and a 20-pin connector with peripherals such as I2C, SPI, UART and GPIO. SparkFun DEV-17588
This compact switching step-down voltage regulator. It has an output voltage range of 4 V to 25 V and a maximum output current of 600 mA. Pololu 3799