New products
New products New products
Best sellers
There are 16539 products.
MicroMod main module equipped with Bluetooth 5.0 Sparkfun Artemis. Equipped with an M.2 connector, it can work with MicroMod expansion boards. SprakFun DEV-16401
Extension board designed for MicroMod main modules. Equipped with a microSD card slot and connectors with SPI, UART and I2C interfaces. It allows you to log data from peripheral devices. SparkFun DEV-16829
Spring-loaded test needle for connecting and testing modules without soldering
Extension board designed for MicroMod processor modules. All the pins are led out to connectors with a pitch of 2.54 mm. SparkFun DEV-16885
The Pololu Pushbutton Power Switches are sophisticated power control alternatives to bulky mechanical switches. The main function is pushbutton-based latching power control, where one push turns on power and another push turns it off.
A set for building a walking robot. The chassis is equipped with four servos, a controller and an STM32F030 microcontroller. M5Stack U086
Ammeter module designed for M5Stack sets. It can measure direct current in the range from 0 to 4 A with a resolution of approx. 0.15 mA. M5Stack U086
The LSM6DS33 combines a digital 3-axis accelerometer and 3-axis gyroscope into a single package. The sensor provides six independent acceleration and rotation rate readings whose sensitivities can be set in the ranges of ±2 g to ±16 g and ±125°/s to ±2000°/s, available through I²C and SPI interfaces.
Voltmeter module for M5Stack sets. It can measure DC voltage in the range from 0 to 36 V with an accuracy of approx. 0.5 mV. M5Stack U087
Module with a light sensor (photoresistor) designed for M5Stack sets. An analog output and a digital output have been led out on the Grove connector. M5Stack U021
Module with GPS PA1616D receiver based on the MTK3333 system. It is equipped with a USB type C connector and a USB-UART converter. Adafruit 4279
Module with WiFi Espressif ESP32-S2. It has 4MB Flash, 2MB PSRAM, and integrates a BME280 sensor, LiPo charging circuit, and RGB LED. Equipped with a STEMMA QT connector. Adafruit 5303
Module with a PIR motion sensor designed for M5Stack modules. It can detect movement up to 5 meters with a detection angle of 100 degrees. M5Stack U004
1 MPx camera module with OV9281 sensor that works with all versions of the Raspberry Pi. Equipped with a shutter and an IR filter, it is characterized by good sensitivity. Waveshare OV9281-120 Camera
Cable dedicated to MyoWare 2.0 muscle tension sensors. It allows you to connect the electrode with the plate in the event that it must be located at a distance from the sensor. SparkFun CAB-19244
Module with 3.5 mm TRS connector for MyoWare 2.0 muscle tension sensors. It allows you to conveniently connect the sensors with the development board via the Arduino shield. SparkFun DEV-18386
Module with a 10 kΩ rotary potentiometer for M5Stack sets. M5Stack U005
4-in-1 module designed for 18650 Li-Ion batteries. It can be used as a 5 V voltage source, charger, UPS and battery protection module
Module with the driver of the resistive touch panel. Equipped with a STEMMA QT connector, it communicates via the I2C interface. Adafruit 5423
Module with WiFi Espressif ESP32-S2. It integrates a LiPo charging circuit and an RGB diode. It is equipped with a STEMMA QT connector. Adafruit 5000